X AUTOHAUX 2 Pcs Front Windshield Washer Nozzles for Honda Pilot EX/EX-L/LX/SE/Touring 2WD/4WD Windshield Wiper Spray Jet Replace 76810-SZA-A01ZA 76810SZAA01ZA

Ensure you put the small gaskets on before you assemble it. They work great once you get the spray nozzles pointed in the right direction and placement on you vehicle

The spray nozzle was difficult to install. The clips meant to retain the nozzle in the car hood needed to be pried into place. The male end of the connector that goes into the supply hose would not seat or lock into place; I had to use sandpaper to remove some of the plastic at the end of the connector to make it fit.After I got it installed, the spray pattern was very poor; instead of spraying evenly across the windshield like the original equipment, it came out in a single solid stream. I would not buy this again.

Normally this brand is excellent for comparable replacement parts. While these nozzles fit the OEM line the spray pattern was not good and did not hit most of the windshield. Ended up returning for Honda branded nozzles

The tolerances are all wrong. At first, the design looks correct. However, the nozzles would not lock into the hood properly and the connectors would not snap into the stock feeder tube assemblies. The design of the tube connectors is incorrect, and the tolerances are too broad. Do not buy these nozzles because they will not work. I was not able to get them to work on a 2011 Honda Pilot. I then purchased the real Honda nozzle from a Honda dealer (much more expense) and I installed it in seconds because the design was correct and the tolerances accurate. I threw the others out because they are worthless.

Doesn’t seat in the hood and barley clips in to the washer hose poor quality product.

These replaced a broken windshield washer nozzle on our older Honda. They fit and worked perfectly. Only took a few minutes to pop out the old and put in the new.

The sprayers seem to be a solid build quality and it is nice they include the rubber seal for the hood. Only issue is that even with aiming the nozzles (great feature) they don't seem to be able to handle the pressure and simply spray out a single stream and lose about half of it along the way.

I’m not impressed so far with this product. Still considering. Struggling to get the items seated securely as they pop out easily. And the spray is inconsistent, heavy in parts of the stream and much less in other. Nowhere near what the original did. The actual nozzle that I realized appears to be amiable is sloppy and moves all over. I’m waiting to see if it even stays where I set it. Expecting it won’t, as loose as it is.Maybe I’m just missing something. But it sure is using up a lot of fluid for the performance it’s directing to the windshield.