Dirty Pro Tools™ Steel Garage Work Bench Workbench Storage With Ball Bearing Slides Pegboard and 12 Pegs Shelf DIY Workshop Station Maximum Capacity 150kgs

The instructions took some figuring out which made the assembly more time consuming. As a comparision, typical Ikea instructions are significantly clearer. Assembly took me about 4 hours of continual effort and for the last few steps I had to employ my 14 yr old son to hold parts while I tightened the nuts and bolts. By the end the kit was 12 washers short so had to run to my local hardware store for those. Otherwise I'm reasonably pleased with the results. The back pin board could do with vertical brace and the drawer is sticky but for the price it's OK.

Good value for the money. Only four stars because the instructions were unclear and you need to work out how some of it goes together. Draw mechanism is a bit "wobbly" but otherwise ok. I did think the work top would be more solid - it seems to be fibreboard and bends a bit in the middle so I may be replacing with a thicker piece of MDF

Product initially did not arive even though all concerned stated it had been delivered (my honesty was put in question in the process) but item was not signed for. Eventually, some time later, we managed to trace it (c/wbadly damaged packagaing) with NO help from Dirty Pro. Pieces were wrong like work drawer inserts wrong size. In all honesty Quality is less than a childs work bench and had seriously augment the build ill be lucky if it lasts a year

Good product once made!!! but to make was a struggle..... instructions too small!!!!!!!!

Good for the price, only good forLight work. Back peg board neededreinforcing. Instruction not very clear.

Not Bad overall the Work surfaces are rather thin and the frame can bend had to reinforce it a lot

Workbench went up in about 3 hours. Instructions could use a larger font and you need to read ahead to make sure it goes together correctly. Front cross member is a bit flimsy. I will probably put some screws through this into the MDF top. Pegboard needs a steadying bracket in the middle at the bottom. Drawer action is silky smooth.

Instructions supplied are small, poorly printed and difficult to make out.Construction was mainly guesswork from the image online.