OTKEFDI OBD 6 Pin Cable RC Motorbike Kline and CAN-Bus OBD2 Adapter

Only a 3 conductor between connectors so only expect 12v to power it with Kline but not can-bus conductors. My ktm needs 5 conductors of the 6 pin to 16. If your stuck with this cable amor need other ways to make it work last minute before a bike trip just find some small gauge wire and a multimeter and the 6 pins can be crimped on back pins with some fiddling abs just connect by inserting in holes of 16pin then squish diagnostic tool in place….or send it back:) I just need to clear troubles enough to get bike out of limp mode for weekend trip. I think all cables sold should state exact connector config but I guess I bought it

KTM wanted $120 to read the code my 2020 KTM 790 was throwing, (engine light on). I used this with a Veepeak ODB reader and it worked great. I read the code, O2 sensor issue and let me clear it.

Needed this to read out and delete fault codes in the ECM of my 2019 KTM 790 Duke and it works perfectly.

Works for 2023 KTM 500exc-f.

This cable allow me to read all the ecu information on my 2022 ktm 500excf . Mostly used it for setting correct idle speed which is important on these bikes so they don’t stall.