15mm Compression by 3/8" BSP Male Iron Thread European Flexible Tap Adapters (Pair)

Bought a Grove tap only to find out it does not fit normal oipes. Upon further investigation of the two page, I see these fittings are commonly sold together. I know why now.One end dcrews into the tap input, the other end has a compression fit to a normal 15mm pipe. It all works well. No issues.The connector is made well. The only thing I managed to do was over tighten the nut on the cold water pipe from the tap. This was not the fault of the compression fit, it's not like it was screaming at me to keep turning. The figvwas still perfect.It's been a month of two now and working very well with no leaks.

Firstly the tap adapters aren’t as per the original image, brass, but chrome with shutoff valves. This seems like an improvement so not complaining.I was converting from a U.K. type tap, Franke, to this European Grohe, hence needed to convert from 15mm copper pipe directly to the base of the tap to 3/8 flexible hoses.These are easy to use and work well and required for most Euro taps.

Ordered these to enable me to fit new tap and hoses to existing pipe outlets. Perfect fit, well made with no leaks and easy install. Very satisfied.

This was a much needed part to fit a euro tap. I have used them before. But not this particular one. The only reason I gave it 4 not 5 is that the middle part was slightly wider than the actual nut size, not like in the picture. That made it hard to tighten the nut above it in a tight space and I had to buy a very thin spanner to do that. I checked the older one I bought a few years ago ( not sure from here or ebay) and it was not as big, I used the bulkier tool I had to hold it in place while tightening the flexihose. It does say hand tighten, but with such a small nut on the euro tap you have to use a spanner and tighten lightly.

I had to have these to fit the Grohe tap that I fitted, they were very quick with the delivery and fitted great

They arrived very quickly, I managed to fit them with relative ease - not having much plumbing experience I didn't realise that these are intended to be fitted to a bare pipe and I unfortunately had to remove a couple of extra valves from the tap pipes before I could get them on. That said, once I worked out what to do, I had them on in a couple of minutes. Very easy, very nice quality parts. I also learned to plan DIY before I start it! ;-)

They do the job ands they’re fit for the purpose. I don’t have any problems with them

Exactly that. Simple to use and didn’t give me any problems getting it watertight.