Rubber Coated 88MM Circular Magnetic Camera Mount and 10CM Aluminium Spacer, Compatible with Insta360 X4/X3/ONE X2/ONE RS/ONE RS-1 INCH/GoPro MAX, Hero 13/AcePro, Car 360 Action Camera Mount

This mount works quite well: it holds very tightly to most car panels, and if you get 2 you can use them together to mount your camera to non-magnetic surfaces like glass.One surprise for me came when I placed it on the hood of my Jeep Grand Cherokee only to find it didn't stick: aluminum hood! Fortunately I had not intended to mount anything there anyway, and since I have two I still could if I really wanted to.(They mention this in the Q&A above, but since people always jump to the reviews I thought I would mention it here as well and possibly save someone some frustration; test with another magnet before ordering!)The holding force is very strong, without being impossible to remove, and the rubberized coating is easy on your car's finish. Just brush it off and make sure there isn't any sand stuck to it before mounting and you'll be fine.In my (extremely) informal testing, it took about 10 pounds of lateral force to dislodge one of these mounted to the slightly curved panel just above the windshield using only the mount that comes with it.So if you attach a mount that is twice as long, it will take only 5 pounds of pressure to dislodge (because of the additional leverage). So use the shortest mount possible for high speeds and use a taller mount only for slower speeds, and in both cases try to find the flattest panel possible to attach it to.Lastly, it works well to put it on the same way you take it off: start by touching the rim of the magnetic disk at an angle to the surface, then set it down flat. Do the same steps in reverse to remove.

Very strong magnetic hold at high speeds. I have not tested over 90 mph, got close.

strong magnet

I tested with various speed in my car. Reliable.

I live in Hawaii and love to capture the drives and views on the island. I stick this on my roof and it just stays put.

The media could not be loaded. Works well with my insta360 Ones Rs 1 inch. I was a little nervous at first driving around with my 800 dollar camera on the front of my car, but after much testing I found the mount to hold tight.

Well the magnet is useless… very weak… now my $400 insta 360 is destroyed…Was only driving 25mph through the small town of Sulpher , Ok and it fell off . Dont waste your money

Not a whole lot to say about this camera mount except is does exactly what it says it does: provides a solid secure mount while protecting your car's surface.It has a cloth like underside that is what comes in contact with your vehicle so there's no chance of damage.Just make sure you remove it at an angle instead of trying to pull it straight off and you should be good.I didn't drive more that about 35-40 mph while this was attached so I cannot attest to top speeds, but I had no issues at these speeds at all.