PIC Gauges 102D-158F Center Back Mount Dry Pressure Gauge w/ Black Steel Case, Brass Internals, Chrome Bezel, Plastic Lens, 1.5" Dial, 0/160 psi Range, 1/8" Male NPT

Great little gauge

Used this as a replacement on my airbrush compressor. No complaints

Great products Great price

This gauge was purchased as a replacement for a sticking gauge on a portable compressor. This gauge is the same size as the factory gauge and works perfectly. It is only 1 1/2 inches and much like the original, is not all that easy to read unless you are right on top of it but the needle does move smoothly thru the entire range and appears to be accurate,

Added to an air spring kit in my SUV. I ordered 3 of these, the other 2 are perfect for paint spray guns. Hard to find affordable gauges in lower pressure ranges

This is an inexpensive 0-60 psi gauge with a 1/8 NPT male fitting on the back of the case. It appears to be reasonably accurate as far as I can tell. I notice that it appears to have an integral pressure snubber in the form of small orfice internal to the opening of the 1/8 NPT fitting. I did not try it on a tankless compressor which would have pressure pulses, but I did note there was a slight time lag on the pressure reading in my application which would indicate that the pressure snubbing function is working. So I assume it probably would work with a tankless compressor.The good:Inexpensive for what it is.Relatively easy to read for its size.Seems to be pretty well made.Room for improvement:To be honest I do not see any need for improvement.

Checked it against 2 other gages, a different mechanical gage and a very expensive digital gage with electric sensor. All were used for fuel pressure. Gage was spot on with the other 2 gages

Gage was junk was very erratic after the first time of using it when it was removed from the pressure source it still said it had for PSI when you're trying to only run one to two PSI that's completely junk tap on it and it would bounce around move up down I don't know how they can market this stuff and call it a pressure gauge might as well been a wheel of fortune would have been just as accurate I went down to the local welding store bought a quality gauge for about the same price works like it's supposed to I wish Amazon would start carrying some quality components at fair prices rather than this cheap crap at the same price which is not a fair price it's a rip off