New 2800 psi POWER PRESSURE WASHER WATER PUMP for Black Max BM80913 BM80919 by The ROP Shop

Perfect fit for my BlackMax pressure washer. Works great.

Detailed helpful instructions about how to confirm bolt pattern, then install instructions as well as support if required.It went together well, definitely a blaster now, I feel better than original...with Honda Power pushing it, unstoppable!

Pump worked flawlessly but don’t throw your shaft key away just in case. New one wouldn’t fit my Honda engine had to use existing one.

Part arrived neatly packaged. All screws and bolts provided fit nicely in the old system.Pleased with the arrival time.

It was fairly easy to install, BUT it is not a direct replacement for a honda pressure washer. Found the feet are thicker than the original part. Barely had half a nut of threads. Had to run to hardware store and procure 1/2 inch longer bolts. Have used it only 3 times since installing and so far works okay.

I change mine after 5 years. It could lasted longer if I would have done maintenance better. Yes is hard to install, I learned the hard way, so here it goes. First, Two people will be great but if not this what I did. I bought three empty five gallon buckets, they are cheap and they can be use later. First I remove the old pump then I put the buckets down close to the tire and the front and lift the washer and with my feet moved the ones under the tires first then the front. My opinion, don't change the key, it's been there for a while and is impossible to removed, believe me I tried. the grooves in the pump and the engine will not be in the same place, that will be amazing if they did. I grab the axle with pin and twisted slowly as closed as possible where the new pump is pointing to. This is the tricky part, forget about aligning the bolts, you must lift the pump and try your best to aligned the key with the groove in the pump, it will be hard, and be careful not to lift to hard, remember the engine is loose. I was able to aligned them maybe in the third try, then I just twisted the pump until the bolt where kind of aligned, put one and slowly moved it into the hole. Put the nut and don't worry about tighten at this time, that will be later. Now the pump is a little steady and you can install the other two nuts and start thighten, just tight the nuts a little at the time and rotate them until the pump is closed to the engine then tighten completely. I hope this help.

The 2800 fit our 2600 psi perfect with no problems. We have the Honda Black Max, and this was the cheapest price for the pump anywhere online. It arrived really quick, and my husband had it install and pressure washing our sidewalk in less than 30 minutes. Highly recommend!!

Love it, great video explaing installation of the unit. Definitely would recommend this item!