LeMotechJunction Box, Electrical Box IP65 Water Resistant Dustproof ABS Plastic Project Enclosure for Electronics White, External Size 3.9 x 3.9 x 2.8 inch

Size of box reviewed: 5.9 x 5.9 x 2.8 (150mm x 150mm x 70mm).I found the material of the box allowed for easy modifications with needed holes to be drilled. The lid fits nicely on the box, with a built-in seal around the edge to keep it weatherproof. Overall, I was very pleased with the quality of workmanship and material of this project box.My project required several holes to be drilled in my box. The pre-scored 1" (25 mm) knock-outs are nice, but I needed a 1-1/8" (28 mm) hole where two of those knock-outs were located. So, I drilled a small pilot hole in the center of the knock-outs and then used a hole-saw attachment on my drill to bore the required 1-1/8" (28mm) hole (see pic with yellow hole saw). My project was to supply and distribute multiple voltages to be used by different devices. I mounted 2 ScanStrut weatherproof USB-A ports (ASIN B071WXWS9C) on the sides of the box. Inside the box, I also mounted a 6 VDC buck converter (ASIN B07SGJSLDL) and a 12 VDC buck/boost converter (ASIN B07N3QT628). From each of these converters, I will route the outputs through the cable glands mounted on the top of the box. The LeMotech box comes with 2 black cable glands, but I used 2 grey ones (ASIN B094ZDSD86) instead of the ones that came with the box. These required 2 custom 12 mm holes to be drilled in the top side of the box..This has turned out to be one of the smoothest project box jobs I have done. Hints for good results: drill holes slowly into the material, and do NOT force the drill/saw into the material. When sawing, proceed slowly so as to CUT the material, rather than BURN it. Since this project, I have ordered another one of the boxes of this same size, as well as another in a smaller size, for use in other projects.

Works. It's a junction box feeding my deck and handicapped elevator.

Excellent quality and good value. If you intend to use the black box "2x NPT1/2"Cable Gland", note that they are smaller than the preformed "knockout" locations for them on the sides. Using a drill bit of the correct size will work, but if you plan to knock out the "holes" on the sides, the resulting holes are too large for the glands. I punched them out and then realized the holes were too large. Plan your work accordingly.

When the product came it had a great build quality and mounting options.

Arrived when promised. Had a nice flat area where I inserted a light sensor. It had "punch outs" scores that were partial thickness - I had to drill them out with a paddle bit. It is not like the metal ones where you can punch them out. l liked them overall though. Would buy again.

Why did you pick this product vs others?:Perfect size. Great weather proof box for electric connections out to the shed. Great quality

Pros: many dimensions to choose from.Cons: wrong material. it's made of very brittle plastic. this product is not shock resistant.*** use a drill / drill bit to remove the knockouts. the plastic is hard & brittle so you can't use a razor knife to effectively score the knockouts. i used a step drill bit to make the second hole.i cracked the box by removing a knockout the standard way (place box on edge over a flat surface and strike the knockout with screwdriver/hammer). normally, plastic boxes are made of a softer plastic. they withstand moderate impact (eg, removing a knockout).*** was an electrician for six years.

Good product