3D Raised Front Hood Grill Letters Decals

It looks great! I had a little trouble getting it on property as there weren’t any instructions but I figured it out.

Looks great. HiEasy to install and stays on well. Be careful for once you place these on car they stick permanently. If you remove them the glue comes off and they can not be reattached without using other glue.

The matte black finish on a glossy black paint look nice and subtle, better than the dark grey that came with it. Great product!

Was easy to put on !

Letters look great and just like the OEM font. One reviewer mentions they come on a template, I found the foam piece they come in to NOT be a template but more just shipping packaging as they do not line up the same if left in the foam. I applied each individual letter one at a time using a hair dryer (or a heat gun if you have one) removing the factory installed letter, cleaning the surface with alcohol, heating the surface and installing the new red letter. I did not like how the letters lined up being left in the shipping foam or “template” that’s why I did mine one letter at a time so that mine went on exactly where the original factory letters were once at. I also measured from the bottom of the hood as I went along to make sure they stayed aligned and didn’t go crooked or lop-sided. This is more than a “5 min install” as one reviewer stated if you want it done the right way and to look good and not like it was done at your local K-Mart. Take your time and do it right and it will turn out great. These letters have been on since September…No adhesion issues (I hand wash the car) no issues to report. Just be careful when washing or drying, you can catch your wash mit or towel on the edges of the letters if not careful but that’s no different than the factory lettering. Would recommend.

Like the easy install. Only took about 15 minutes to tape template using a tape measure and clear scotch tape. Lettering was then easy to attach and the end result is Awesome! See photo.

I had OK results with these. I'll probably replace them in a few months. There was no room for error seems like. Once the letter was LIGHTLY placed, it was stuck. I had one get off a little and there was no moving it. I had barely placed it on the hood. So now one letter is off. I'll probably buy more later and pay a trim shop to do it.

Not sure if it is like the OEM spacing but I used the foam that comes with and was super easy to install and looks great!