Router Table Insert Plate, 300 X 235 X 9.5mm Aluminum Router Insert Plate DIY with 2 X Router Table Insert Ring and Screws for Wood Trimmer Router

Cheap but functional enough for my needs.

I was pleased with the plate itself and was able to fit it into my workbench. It also accommodated my router well due to the position of the drilled screw holes. The only let down was both of the central router rings do not lay flush to the plate surface. They lay some millimetres below. They really ought to have been flush to be of suitable use.

Good basis for my router table. Originally modified for a Black and Decker now I have a Triton installed. Had to modify heavily for the lift action but relatively easy to do.

This product has the potential to be a best seller if the manufacturer had paid a bit more attention to finish and function. There is an obvious lack of quality control in the manufacturing process. The central hole was poorly made and a had sharp edges and raised serrations all around, enough to cut fingers and at the very least dig into and damage any workpiece that would have to pass over it. It came with two red plastic inserts that were of different thickness with one being slightly proud of the work surface and one being lower than the work surface making them next to useless for their purpose. Other reviewers have said that the table inserts they received were not flat, mine was flat but looked like it had been kicked around the factory floor!

Had to drill holes for my router to fit the plate Dewalt 625, filled holes that are not required, need to had other tapped holes on the perimeter for leveling the plate up other than that it is ok.

The two red 95mm dia plastic plates are warped,not fit for purpose.I will have to sand them down to the level of aluminum insert plate.Poor value for momey.J L Co Down Ni

Well made item at a very reasonable price which was delivered quickly.

...

Der hier angebotene Fräseinsatz ist vom Grundgedanken her gut. Jedoch ist dieser schlecht verarbeitet und nur mit nacharbeiten zu gebrauchen.

Upon opening the package I thought the piece was dirty but it is actually a bunch of small air pockets in the aluminum from poor casting. I put the plate upside down on a flat surface and found that the face is about .050” out of flat. I should be able to pull it flat on my router table but I shouldn’t have to do that

Edges will cut you if not ground down.

The plate is not flat. See the video for atrocious rocking motion. Also, the surface is pitted and filled with imperfections.Was this a reject? Is this some sort of a joke?Regardless, going back asap.

Took a lot of finesse to adapt it to my Bosch router but it’s ok. We made it workThank you for a good product