Creality Ender 5 Plus Full Hotend Kit, Original Fully Assembled Extruder MK8 Hot End Kit with Aluminum Heating Block 0.4mm Nozzle Teflon Tube for 3D Printer Ender-5 Plus/Ender 5 Pro/Ender 5

This was a perfect fit and an exact replacement for the original complete hot end. It only took me a few minutes to install and everything plugged in exactly right. .I was worried about the wires fitting and the length but it was perfect. I would recommend this product if you need to replace the hot end. I only had to add the wires in the loom for the auto level.

I have Ender 5 Pro and the fan wires that came on this are reversed. additionally, the thermistor appears faulty, when I plug in the thermistor cabling the printer emits a prolonged a prolonged beep alert and the temperature of the themistor reads as -14c, which is the same temperature read when I dont plug in the thermistor at all. Will play with it a bit and see if I can correct the issue, but it seems rather low quality and I will probably return it. **UPDATE** the retaining screw that held in the thermistor was overtightened, crushing the delicate thermistor wire insulation and shorting them against the hot end. I don't recommend this seller. Poor quality control.

As advertised. Replaced my factory hot-end with no problems.

It works... after you fix the reversed wires on both of the fans. It's an easy enough fix, but annoying and takes away from the plug and play convenience.

Completely wired replacement. All I had to do is slip the auto level wires into the new cable keeper and replace all the zip ties.

Fan doesn't work and it's brand new!! Waiting to see if the work fan actually works. According to others it won't... terrible. I bought aftermarket and used it 24-7 for a month without any problems!!

After the fan blew in my Ender 5 Plus. I could of just ordered the fan itself but the wires were never long enough. Soni replaced the whole thing. Everything is a perfect match and fit.

Came back to edit my review. While the below is still true, it was very easy to install, the fan on this one is junk and it either doesn't run and the filament gets too hot and travels up the line too far or runs nonstop and cools the filament so it backs up. Super disappointed as it's 8 days outside of the return window 🙄 would be willing to return for a replacement and try again, but not willing to spend the money to try again and hope it's just faulty on this specific unit. I'm new to 3D printing and didn't understand the importance of the blue clip, so my Bowden tube melted into the hot end....found this replacement with 1 day prime shipment. Wiring was perfect and 15 minutes later, I was back to printing!! As plug and play as you can get. Kit comes with a Bowden tube and a single screw. I had also ordered a Bowden replacement kit, so used the hardware from that kit to fully attach the Bowden tube. Also pulled the auto leveller from my old hot end, as I def need all the help and guide rails I can get right now!! Lol

Colocado y funcionando sin problema.

Soucis avec la sonde de température, dommage

Lies sich einwandfrei einbauen und hat mich bei einer komplett verstopften Düse gerettet. Ich habe immer ein Hotend Kit auf Vorrat da.

It does not work with Ender 5 pro. Probably wiring different - printer beeps and shows an error. Cables are longer than the original one - that is the good point

The fan assembly does not work on an ender 5/pro. The wires are in the wrong order and without the fan the whole thing clogs and is almost unfixable. If you do buy it, hopefully you have your old fan assembly to attach since this one does not work!