Heavy Duty Toggle Switch 20/15A 125/277V, 2 HP with Waterproof Rubber Boot UL cUL Certified

works good

I use this switch to replace the ignition switch on my motorcycle. Excellent quality weather tight connections with the weather tight boot on it makes life a whole lot easier and never have to worry about corrosion or water getting inside the switch excellent quality would definitely buy again if I need another 1

God switch, worked well in exterior box. Has rubber boot on lever to keep hands off metal in out side uses.

I needed a waterproof switch that didn't have an LED, and this fit the bill. The waterproof cap didn't go on super well, but other than that, it works as advertised.

Pre- installed wires were helpful

I replaced the switch in an auxiliary fuel tank for equipment. The switch was definitely heavy enough and the wiring was also it did the job just great should not have to replace aI replaced the switch in an auxiliary fuel tank for equipment. The switch was definitely heavy enough and the wiring was also it did the job just great. Should not have to replace a switch for a while. It’s heavier than what was in there.

Devise works as described, and feels sturdy. Only thing to note is if you want to use the rubber “water proof” cover over the switch, you will need to clean excess rubber from the inside threads of the rubber nipple to screw it on all the way. I put water proof in quotations as it does not really help much unless you install this somewhere where no water will get behind the mounting surface, only on the top side. Light rain or splashes will be okay but submerging this will for surly cause corrosion and the part will fail. Installation was at easy, drill a half inch hole and place it in and tighten down.

The switch is heavy duty and switches with appropriate amount of pressure. Durable enough to switch off and on with foot without having to worry about damaging the switch. I wired with a redLED light to indicate in the on position.