Agri-Fab63768 Assembly, Implr 12-Inch Dia

Perfect, this and other parts saved me from buying a new snowblower

After assembling the augers and impeller the impeller was grinding on the housing. Disassembled and put a washer on as a spacer reassemble and now work. Just make sure you have a washer for the shaft and use anti-seize will slide together easier.

Fit perfect way cheaper than John Deere

Spring pin holes off by 1/8 inch so when installed it was too close to the back hood wall and would not turn. I reinstalled it with one large washer to compensate for the wrongly drilled spring pin holes, just now it has less room between the auger pulley and the hood wall, may work once I get the correct belt on and a new electric lift winch.

I looked up this part number several times to make sure its the right one and it is. We finally got to installing this on the blower tonight and the Auger Shaft 2 drilled holes where aprox 3/8" OFF!!!! this made the Auger press against the back and not allow it to SPIN freely! I believe it took 2-3 months before this product arrived and we are getting our first snow fall no and Can't wait to get another one. with a bunch of modifications we did manage to get this together but it should have just Slipped on with out any trouble.Sadly this wasn't our only trouble. the new Side arm Drop pin ALSO was WRONG and about 1/2" to short for the Cotter pin.....we had to straighten the old on and reassemble with it. VERY DISAPPOINTED!!!!!!!!!!!!!!