(2 Packs) Phone Swing Compatible for Pokemon Go Walker Cellphone Pedometer Accessories (Mute Version)(USB Cable) Quick Step Earning Device

Although there is two devices, I'm only going to review the one I used. I used the one where it looks a little T shaped, and I put an Iphone 12 pro in it. There is some assembly required. The two rails must be inserted into the base. Make sure you put the right one in. One set of rails has a notch at the base, and one set doesn't. You can use two power sources. It comes with a USB cord, but the plug is not shaped like a standard phone charger plug. It will plug into the base. As an alternate option, it will hold 2 sets of AA batteries and can be powered that way if you don't have the cord available but have access to AA batteries. It also does not appear you can charge your phone while it is swinging so keep watch on your phone battery if it is important. On my setup it took about 30 minutes to show 1.2 km on the eggs. The base rocks a little on the hard desk surface I am using. I ended up putting the small air bubble bag that came with the device under the base, and now its quieter. For now while testing I put it on the egg screen so I can periodically look at it to see how many km it is showing. As for the other device that looks rectangle shaped with circles, I hooked it up to USB and it does swing although I tried flipping it around and it swung better. I have not tried a phone or other device with it. The very top did have a crack in the plastic. It shouldn't hurt the functioning of the device. I didn't notice until I picked it up at the top and noticed the crack.

es fabuloso!

Plug it in, Doesn’t move. Manually push it to start, does nothing. Will not work at all. 2nd one, the base is so tall it hits the swing part so u physically can not even push it

No desperdicies tu dinero. Baja calidad, no se mueve correctamente y no funciona

The cradles are a little bit on the small side for my Samsung trio (a54, a15, s24+) but between the two cradles all phones fit (with the otterboxes).There are two different sizes of vertical supports that need to be paired with the correct base. Both bases allow for USB charging but one also allows for AA (4) charging as well.I was having problems keeping it going until I rotated the unit to check for problems caused by an uneven (not level) table surface and was able to find an orientation that would continuously rock with no outside assistance needed.Another note specifically for the double cradle is that the bearings need to be placed squarely on the support ends. This may require pulling one of the ends over less than 1/4 inch.