Suptek Ceiling Projector Mount, Universal Wall Mount - Rotate 360, Swivel 90, Tilt 90 with Extension Pole (210-540mm), Black, Up to 13.6kg

Managed to assemble it; it should work on any projector but is a bit fiddly and the instructions seem to be copied directly from microfilm (ie difficult to read!). Once mounted with the proctor on it is fine, but it did feel a bit flimsy. I would worry if I had to mount at an angle rather than vertical.

Great quality unfortunately its to heavy for my ceiling

Does the job

Highly recommended

To hand a Philips neo 720 but won’t reach the 12” it claims.

I bought this mount because of the ability to extend it. Had it at full extension and all was good and tight, well until it went crashing to the floor! Very angry and disappointed!

It's cheap and pretty flimsy to put together, and trust that your project is going to stay attached. Don't over tighten the bolts and they all round off the threads, I ended up adding my own bolts with lock nuts where I could.

The mount itself isn't that bad but it comes with some of the worst instructions I have ever seen (well barely seen looking at the size of them!). This has resulted in nearly 2 hours trying to figure out how to install it, then incorrectly installing the bracket sideways. I now have 4 holes in my ceiling that will need polly filling! Also it is falsely advertised as being adjustable from 210-540mm. will not adjust as low as 210...more like 300mm. For the price I can't be bothered to return and have bought an official Benq mount instead.