these whole car decal sticker are only made for you. contact me by emial when you made the order, so we can custom /tailored the sticker for you. Dry paste method: 1, clean body, keep dry. 2, the transfer film ( paste in reflective stickers on the transparent plastic film ) together with stickers to lift; in general, the side of the stick slowly, side by side, bottom tearing paper tool scrape. 3, if the car is less than 10cm in length and width, can also be transparent transfer film and stickers all torn paste. But be careful, don't fall accident ground adhesion or sticking dust. 4, with a clean cloth or scraping [such as calling card or credit card ] in the transfer film on repeated forced oblique wiping or scraping a few; until the car has no bubble, and then rip [ clear ] transfer film can; advice24 hours don't wash car. Wet sticking method: 1, clean the body, to be affixed to the body parts with the sprayer spray water -- is mainly used to reduce viscosity, convenient to adjust the position of sticker. 2, determine the need to place, the transfer film ( paste in reflective stickers on the transparent plastic film ) together with the car from right to left to [ or from to below] raising side and rag press affixed to the car, then the side of the stick, side by side, bottom tearing paper cloth flattening. 3, meet the door handle or collision shall according to the material cut and into or out. 4, timely adjust the graphic location identified as correct, scraper repeated scrape water and bubble, using the scraper is from right to left oblique scraping; finally torn transparent transfer film. 5, the doors and seam with a knife cut inward equipartition, wrapped. 6, try to make the car in the water dried, the conditions can be hairdryer moderate heating drying. Suggestions:24 hours so as not to exposure, within 48 hours of not washing.
Trustpilot
5 days ago
4 days ago
