A-Premium Manual Control Module Blower Motor Resistor Compatible with Infiniti & Nissan Vehicles - Frontier, Pathfinder, Xterra, Titan, QX56, Quest, Armada - Replace# 271505Z000, 271507S000

This was used to fix my number 1 and 2 fan speed in my 2011 Nissan pathfinder. Took 5 minutes to swap out old with new and just like that I have all my fan speeds working.

Excellet product that works perfectly. The cure for a blower motor that only works at the highest fan speed for heat or A/C. Simple replacement. In my case with 1/4" ratchet, short extension and 7/32 socket. Located under and behind the glove box left of center. Unplug the wiring harness connector (in my case white) remove the screws, part drops right out. Install new one, screw in and plug in. Bingo!............I hope this may help someone. I've done this repair in the past.

Easy installation and got my #2 fan speed working again.

Works as it should like new 2004 Nissan Titan. When your fan only blows on certain speeds it is the resistor pack that's bad. I've replaced a few in different vehicles . Cheap and easy fix

*Update, dropped a star since it quit working after 16 months, just outside the warranty period* A/C has been working properly since install. I wasted too much time looking for a part with good reviews after seeing all the comments about poor reliability. This is probably the easiest part to change out on my XTerra, just buy it...if you get a bad one get a replacement it's like 3 minutes to install. For some reason the bolt that holds this in is like a 5.5mm, 7/32" fits it, 6mm will just spin.