Pattern Flush Trim Router Bits 1/4 Shank, Bottom Bearing Pattern Router bit Set, 1/4 Flush Trim Cut Router Bits, Handy, Durable & Sharp for Home DIY

nice product ....work good

These bits arrived nicely packaged in their own little plastic tubes and then within a cardboard box. They even supplied several extra replacement bearings and set screws with the set. The bits themselves look to be well made. I have not had the time to actually use them yet, but see no reason why they wont preform as hoped. For occasional amateur woodworking, these will do just fine Update...I have been using these router bits in my cordless 1/4 inch router for a few weeks. They work very well. They seem sharp and accurate and cut through hard maple and cherry with littke effort. These are a real bargain.

They are not bad for the money, BUT, my first cut with these was on a small piece of maple, routing out a 3" circle. In 30 seconds the bit broke on the bottom edge. I just used a longer one and adjusted the router to finish, but they should not break cutting 1/4" into maple. Amazon/seller replaced the set, but common man!

I decided to install my first pocket door and one thing I quickly discovered after tearing into the wall and buying a slab door was the need to make some jigs and rout for the handle and pull hardware. Despite my collection of over 36 router bits, a number of which I have never used, I didn't have any of these - flush bits with a guide wheel at the shank instead of the tip. This turns out a perfect collection for pocket door hardware, and the assorted sizes - I thought them a little overkill - turned out to be a godsend as I used three or them for this one small project. I did a couple of test cuts on scrap and it's a good thing I did, just to get used to using these for two depths (shallow on the outside and deep on the inside). To my surprise, I found it better to cut the smaller, deeper cuts first so I could get a better site on clamping my jig for the next wider, shallow cuts. These came sharp sharp, each in a nice and secure little clear case. Deep shanks for good purchase. No idea how long they will last but for this first project, much better suited for my task than I realized when placing the order. Very satisfied!

I used these bits to create a wood hinge jig for my custom door jambs, very sharp and quite useful.

The 1 inch bit broke (cutting edge broke off) while using it lightly at low speed. Not impressed. The smaller bit is working so far.

I had to replicate some pieces off a template and these bits did a great job. Very happy with the product.

Did the job, only used 2 times