Genuine Honda (35750-TA0-A02) Power Window Master Switch Assembly

I ordered this as a replacement for my 2009 Honda Accord LX and it works perfectly....after it has been programmed.It is really simple to replace the Power Window Master Switch. The panel that holds the switch on the door pries straight up, so use something dull that won't scratch the handle. Slowly pry the panel up and away, and you'll see two electrical cables attached on the bottom side. Remove the 4 small Phillips head screws that attach the switch to the panel and pull the switch away from the panel.The power cable that attaches to the Power Window Master Switch has a white tab at the top, with a latch. Press down on the latch and rotate the white tab clockwise, and gently pull the cable away from the old switch. Attach the cable to the replacement switch, then screw the switch back to the panel using the 4 screws you removed earlier. Gently slide the panel back into the hole on the door, pressing around all sides until it is flush.I checked it once I installed it and the windows went up and down and the doors locked and unlocked. The auto down feature on the driver's door window did not work at this point. The keyless remotes locked and unlocked the doors, but it did not roll all 4 windows down after pressing the unlock button 3 times and holding it.I then programmed both of my keyless remotes (program all of yours at the same time if you have more than 2) using the procedure below, and everything works perfectly now. The dealer wanted $375 to replace the Power Window Master Switch, but I did the replacement myself and saved about $250 - follow these steps and you can replace it yourself even if you have little mechanical ability.To program your keyless remotes - do this:This procedure only programs the remote portion of the key and NOT the key itselfHave all remotes for the vehicle on hand.Make sure all the doors and rear hatch/trunk are closed during programming.Only need to use 1 remote to get into program mode but all remotes must be programmed during the same session.Each step must be completed within 5 seconds.1. Sit in the car with all doors/trunk tightly closed2. Turn the key to the ON position, marked by “II” on the ignition bezel so the dash lights come on, then within 5 seconds press the “Lock” button on the remote for 1 second or so and release the button.3. Turn the key to the OFF position, marked by “I” on the ignition bezel – dash lights go off.4. Repeat steps 2 & 3 three more times (A total of 4 times) each step must be done within 5 seconds of the previous step.5. Upon the 4th turning of the key to “ON”, press the lock button on one remote, the locks will make a cycling sound (clunk), locks will NOT lock or unlock at this point, they will just make a noise. The system is now in programming mode. Do not turn key off.6. Within 5 seconds of entering programming mode and within 5 seconds of each other, press the lock button ON EACH remote you are programming, for a second or so and release. This step needs to be completed within 10 seconds. Each time a remote button is pushed, the locks should cycle. Up to 3 remotes can be programmed.7. Turn ignition completely off and remove the key. Step out of car and close door. The remotes should be programmed and should work. If you have a trunk/hatch release, the button for this feature needs to be held for a few seconds before the trunk/hatch will “pop”.

This was right what I needed my power switch button broke on my 2011 Honda Accord lx and this one works perfect . Very easy to install no more than 5 min it will take . Very happy with this product and how easy it is to install

This is an OEM part so it will fit even though the original part number was 35750-TA0 A010. When you are done your auto window button will not work. And neither will that fancy remote window lowering feature it has. Programming is really easy. I have horrible reading comprehension and even I got it.

Easy to install and works great

I ordered this because my drivers side window wouldn't go up. It wasn't the motor so had to be the switch. This was exactly as described and what I needed for my 2008 Honda Accord LX Sedan. Thanks!

Super simple install great OEM part highly recommended.

Very simply installation. Works great.

It fit perfectly and worked great