Fluke TP88 Rigid Back Probe Pin Set, 2" Length

Have been using these for a few years, and they are great for small pins. Spend the money on good ones. I bought a cheap imitation set, will not do that again, get the real ones like this.

They work great, and they're nice and sharp. The only thing I dislike is how long they are, if I could find some just like these but short, they'd be perfect.

I use these to diagnose MCUs on circuit boards. The design is pretty nice. You have long insulated stems so you can get a good reach all over the board. Works very nice under a good microscope. No issues with performance. But the cap that attaches to the lead is very fragile. Mine cracked pretty early. Fluke sent a new pair very quickly. Good company.

Great for the price, would purchase again. After a bit of use the sheathing will slide off the pins continuously. They have a protective cover you can place back on after use.

These are *very* sharp pin probes which attach onto standard 2mm test lead metal probe tips. The attachment is a friction fit, without threading, so care is needed to prevent pulling the probe out of the TP88. I use these tips with a set of TP175E probes, and they work great for hitting fine traces on circuit boards and for probing connector shells. If your boards are conformal coated, this will go right through the coating to give a good reading.One thing to keep in mind is that these tips are only rated for 60VDC. For typical uses this is plenty, but always keep in mind what the voltage you are measuring could be.

They very easily slide over the tips of my existing meter leads, I thought my leads needed to be threaded but that's not the case. Small tips to get in behind molex plugs.

Are your tips just nubs that can barely make contact with a 0402 component? Need a sharp point to get at those tiny pads, but can't fork out the big bucks for a pair of pointies? These are just what the technician ordered!They aren't spring-loaded, though. They are, however, extremely sharp and come with molded flexible boots that keep them protected.I'm so impressed I'll definitely be buying a set of the spring loaded tips!

Very happy with these probe tips. They are a little flexible which is good for reaching tight areas but for most part are rigid with a nice sharp point on the end. The rigid part of the probe is about 1.5mm dia which is great for reaching tightly populated areas on PCBs. These fit very nicely over my standard set of probes.