YONICO Raised Panel Cabinet Door Router Bits 1-3/4-Inch Diameter 1/4-Inch Shank 12130q

Worked well. On 12 feet of lumber. No idea how durable it may be, probably never use it again

This product is a good value. I liked the way the bit cuts and stayed sharp.

impressive quality, however far too big to fit my router. in fact I'm not sure what router could take a 3 1/2" bit.

It works well if you let it set the pace.

I finally used this bit. I first tested the bit on pine. It left some shavings still attached. This was probably because I wasn't careful which way the grain of the wood was coming out of the face of the board. I decided to try the bit on red oak. The bit perfectly routed 52 linear feet. I will buy this brand again.

I needed a bit to make my cabinet doors look better. This bit cut so smooth. The finale product is beautiful.

Well made but not the sharpest. Took 6 passes to raise drawer panels. My Freud and CMT bits of the same size can do it in 3 passes.

I decided to try this brand since my local supplier didn’t have the exact profile and cut depth I needed for a cove raised panel door. At less than half the price I’d have paid for a Freud or Whiteside I was pleasantly surprised with the results. I have the Porter-Cable 3hp motor in a Jessem router lift and table so the setup was easy. Using the lowest speed of 10,000 is advised for this large diameter bit and got no burning in red oak. Normally I’d prefer a Freud bit with Quadra-cut for cleanest cross grain cuts, but for my small project of one door this product did not disappoint.