AXHJ Balloon Column Kit 2 Set, 65 inch Height Balloon Stand with Base,Pole, Balloon Rings,Dot Glue,Tying Tool,Flower Clip,Balloon Pump,Balloon Stand Kit for Birthday Wedding Party Decorations

I purchased these balloon columns for my daughter's 5th bday. They were really easy to install. All parts that were listed were included. Pretty lightweight, obviously, but after I added the water in the weights, they were pretty sturdy. Even with the water though, I feel if you had them outside and a good, hefty wind came, they might tip over. Might have more reassurance with sand in the bottom for outdoor use, instead of water. My only other critique is that because of where the water intake/drainage valve is, it was really hard to get all of the water out of the base parts. I had to shake it out and even then, it all didn't come out. Just kept the stopper off to try to make sure the water evaporated.

I am definitely buying some more of these. The stands work perfect. I have used it for multiple parties and I always get a complement on the decorations. I recommend.

This is only good for short indoor balloon projects....it’s doesn’t work outside, it’s super flimsy so can only be so tall, even with the extra weights, but if you apply any pressure, water spills out of the weights....I used it for party decor to gold foam core signs and a few pieces of candy but it was too tall to stand up straight

Too flimsy! Couplers don't hold tight the tubes and get disassembled without trying and even by just wrapping the balloons around it.The balloon holders do not work well, you need to wrap the balloons and the rods are kind of thick for that making it difficult to achieve. Especially with the rods dissasembling as mentioned above

Genial 😀 ! Me ha encantado, básicamente lo compre solo por las bases, pero traen en adicional muchos ítems de gran utilidad . Recomendado

Hi, I really like the balloon columns, but sadly I lost the very top of one of them. The plastic top balloon holder clip, during a bad windy thunderstorm, the wind ripped the top balloon oof the column along with the holder clip and was blown away. Is there anyway I can purchase just the very top piece? I included a picture of the piece I need. Looking forward to a response. Thanks. 🎈

These columns are so flimsy. The water weights held the base down, but as soon as a small wind came the entire stand came out of the base and fell apart. Balloons flew everywhere. I've purchased cheaper columns that were much better quality.

There were pieces missing, but we made it work. The balloon columns weren't tall at all and they would have been fine if it were an indoor party. However, the slightest bit of wind would knock the poles out of the bases, despite having used the glue dots to "hold it in place". We had to tie fishing line around the columns and tie them to a table so they could stand semi upright. Very disappointing.