MaxlineM8201 Dual Port Outlet Kit with 3/4-Inch Tubing and 1/2-Inch NPT Outlet Port

Pricey for what is, but super stout. The ports on all sides sealed the deal for me. Not sure what one of the other reviews was going on about, saying the threads are not npt spec, but I didn't have any issues. The maxline fittings are all NPT, so I can't imagine where that could be coming from.Top port is 3/4 npt. The four on the front/sides are all 1/2, and the bottom one for the included drain was 3/8 iirc.

Very nice air line splitter, solidly made and comes with a lot of useful additions to make sure it can get into action right away.It does seem to have more ports than I recall asking for but i'm not too concerned about it. It would be nice if it came with enough plugs for all the holes, something I can correct on my own most likely at the hardware store but a minor nitpick.

Great manifold compared to their previous version. We have multiple of these throughout our shop and have been very pleased with the quality and performance. Will buy again when needed

Love it I truly enjoyed the fact that it has two outlets. I have one connected to the an auxiliary system outlet and the other to my hose reel.

I love the Maxline system, we installed 300 feet of it in our shop. We attempted to install shut off valves at each outlet by installing ball valves between the manifol and the compression fitting that goes to the maxline. The threads are not in spec or anywhere close to npt. The plating is terrible and readily chips off, causing leaks. The base metal is very poor quality. It look us a full day to finally get the leaks reduced, but each one still leaks slowly. We had none of these issues with the single outlet design.

Expensive but nice. Durable and have held up in my shop.

Works as it should

Easy to use simple to install