ASD2x4 Surface Mount Frame for LED Flat Panel Light - Aluminum Surface Mounting Bracket Kit for Drop Ceiling - Low Profile Back-Lit Panels Mount Kit, White

Picked up an LED Ceiling Light. Needed a mount. This mount worked great. Easy to mount and assemble. Once finished. Looked like a Pro had installed the light. Wife made that commit not me. Although I will have to say it does look nice.

The item came with no literature and the sheet rock anchors it came with were terrible. I had to buy separate ones just to complete the installation.

The product was perfect for my surface mount on kitchen ceiling. Anchors in sheet rock are fine as the whole unit is light weight and it slid into the frame like perfect. u tube was very helpful in squaring it up and especially wiring on an existing box. Touched the end cap screw heads with a little white paint to match and it worked perfectly. Could not get one of these frames from Home depot. Figure that.

Happy with final result, but really should come with the following instructions that would make your chance of success much higher:1) Assemble frame completely - all screws tight - this makes the screws easier to install once installed2) On the end that is going to be removed for install, remove JUST THE 2 SCREWS that will be impossibly close to the ceiling (and therefore hard to remove). Leave the other 2 and the end piece in place for now3) Locate the frame in the desired position (helper absolutely a necessity!)4) Notice that the frame is VERY wobbly in this state, so you MUST verify that the corners are square before you completely tie all fasteners down5) Now remove the additional 2 screws on the end to be opened, and remove the end piece6) Slide the LED panel in from the end and complete wiring. Be warned that the frame is weak enough in this state that the panel will slip out and fall if not suspended. So one person needs to hold the panel while the other does the wiring. If the rails were thicker they wouldn't flex so much to allow this to happen7) Install the removed end piece and replace the screws. The 2 near the ceiling really require a flex driver, u-joint drive, etc. in order to install them. But since you pre-threaded the holes in step 1, this is not too hardBetter instructions, heavier gauge metal (so less twisting) and white screws (rather than silver) and would have given 5 stars

Great product, wish I knew about it before I bought the light so I could buy together. No biggie because this was shipped in two days. Hardware was quality and easy installation.

Great quality and ease of installation. I will buy more.

As always. Throw away the screws and such and use your own. Product itself came out of the box looking great. Felt good. Not scratched or anything.But upon screwing it together, it became obvious it was flimsy and needed either a thicker gauge metal or more supports. The corners made for screws are a bit tough to get quite right and if you don’t, the whole thing is all wibbly-wobbly. Technical term…Anyway. Looks ok in place. Not worth replacing for sure. Just pay attention to the corners and make sure they’re tight before you hang it up.

This is easily the worst product I have used in a long time. I suggest DO NOT spend money on something this poorly designed

Perfect for low ceiling

Reasonably good product. This stayed pretty square while mounting. It didn't come with instructions, but I figured it out without problems: assemble the 4 sides, mount 3 sides to the ceiling, remove the fourth side, install the light, replace the forth side. The last side just doesn't get fixed to the ceiling because the holes are hidden after the light is place. I found it useful to have a second set of hands available. The corners fit together reasonably but not perfectly when the pieces come out of the box - a small adjustment can make the corners match perfectly.

Easy to put together but a little tricky to get the frame square enough for the light to fit in securely.

Fit perfectly.

When assembled, product sizing was not correct. Had to make too many adjustments and even then, the electrician could not get it aligned.