Fits Jeep TJ Black Coated Diamond Plate Full Top Fender Cover with Bend

Looks better than 2 rusty fenders! Just used a wire brush on the rust and treated with rust reformer before drilling a few holes for the hood latches and pop riveted into the fender. Good product to keep my RV toad looking fresh.

What an improvement , they look absolutely AWESOME , my fenders wasn't even rusted , I just added them for thar rugged look and they certainly did that , I love them !!

A good option for covering typical fender rust on wranglers if you dont want the hassle of buying new ones or completely refurbishing the rusted out areas. Also adds a nice black accent on the body. Installed fairly easy and fit pretty well on my 04 wrangler rubicon. Came with about 16 black rivets, i used 6 on each side. You will have to drill holes for the hood clamp, i also drilled holes for the rubber piece the hood rests on but you could just leave those off if you didnt want the extra hassle. I also had to loosen the plastic fender so the bend could contour the metal. A few things I did not like, the bedliner seems kind of soft and i am worried it might scrape off over time, or perhaps even during high pressure washing (only time will tell) also they did a messy job applying the bedliner, the top was coated well, but there is a bunch on the bottom it would have been nice if they cleaned it off. Also in my opinion slightly over priced, but overall as long as the bedliner stays in tact i am satisfied.

I just finished installing these fender tops on my 2003 Wrangler. They are well made and fit just fine. The bolts for the hood latch were rusted on so I cut out the top to fit, no problem. I also applied 3 coats of bed liner to the Jeep fender and the top. This makes a much better water tight seal. I did this to my other body armor parts and it makes a much tighter fit. I did not want a diamond plate look because the rest of my jeep armor is smooth steel and the bed liner on the top covers it quite nicely. The provided pop rivets work just fine. Great product!

fits great and easy to install.. '98 TJ

Bought these for my 99 tj and they make my jeep look great! Very easy to install just drill then revit. These are made very well. I recommend these and the company. They have great made products!

I had bought this to go over the rusted fenders on my Jeep..The fenders rotted to the point of replacement. They are good looking and seem well made, but not mountaong them I don'thow long they would last. The paint is sprayed over the top but not on the bottom..

Product arrived after two days of placing the order and it was well packaged. May be too well packaged it took me 5 minutes to get it out of the plastic wrap. I was able to drill the five holds into the aluminum sheet for the hood latch and hood bummer easy enough. The 3/4 inch bend does touch the fender flares but I think it looks great. Attaching the plate to my 2006 Jeep was easy. A few holes drilled through the plate and the fender and I used the included rivets to attach. I only used 6 rivets 16 were supplied.