ConPus R12T Fuel Filter Water Separator 120AT NPT ZG1/4-19 Fitting Complete Combo Filter For Automotive Racor R12T 10 Micron Marine Diesel Engine 3/8 Inch NPT Outboard Motor Durable Spin-on Housing

The ability to see water or other contaminants in my fuel , a sportmanWith 4 different kinds of boats i don't know how i got along my entire life without this. 1 easy to see a problem- 2 size is perfect for placement. 3 price is reasonable. I don't want to use it the word cheap because this product is far from that. Oh it comes with everything you need, but the screws you need to mount it!!!!!

I bought this and installed on my kubota bx to replace 2 inline filters that are hard to get to so far i am extremely happy was a little bigger than i expected but this also separates water which i didn't have before that i wanted i located this in front of the injection pump on the side of the engine i have not replaced the side cover yet but i think it will fit under no problem

Quality for your money.

well made , installed one on my boat and installed one on my zero turn Cub Cadet .

Came out of the house going to the detached garage and smelled gas. Got in the garage and gas was draining out of the boat drain plug onto the floor. The clear plastic cup on the bottom of the fuel filter softened and the o-ring swole up allowing the entire fuel tank to drain overnight. Not happy!

I have marine application. I'm renovating a 1989 Boston Whaler Revenge Cutty 25. It has twin 70 gal fuel tanks. On tank was disconnected due to fuel line issues. I corrected the line issue but then discovered that due to the long idle time this large tank had collected a substantial amount of condensation.,gallons ... so I used the filter to gradually remove the water to return this valuable tank to service. Regards. Lee

Installed this unit on my old backhoe. So far it seems to work ok, however: The pipe threads are short and shallow and dont offer a lot of engagement, which is a bit concerning. Annoyingly, the bleeder vent is in the wrong place and if you try and use it, it just lets out fuel without releasing much air. Next service, I'm going to install a small ball valve on the unused discharge port and bleed from there.

Worked fine in the beginning. After2 weeks it started to leak when I squeezed the bulb pump. One week later the engine just sucked in air thru the leakage and would not start.