Motorcycle Helmet Chin Mount for GoPro, Full Face Helmet Jaw Mount Holder Strap with Extension Swivel Arm Kits Compatible with GoPro Hero 10/9/8/7/6/5 Action Cameras

I've been pleasantly surprised by this mount, we've used it for some hours mounted to a leopard leo-819 helmet and we've not had an issues or had to touch it at all. The only issue is that for some helmets (including the leo) it may block the venting, it can also prevent the visor closing fully (though this personally isn't an issue for us) and it may cause issues if you have a chin wind deflector (the leo also has one of these, but it didnt bother the rider that it was flattened). While we usually use it for standard speed riding, it has been tested at higher speeds and still didnt budge. I'd definitely recommend this as long as the listed things arent an issue for you.Edit: we've also tried this on a AGV K-3 SV helmet, which has a more pointed 'bill' front than the leo, it still works and fits perfectly fine.

The only way I could fit this on my Shoei helmet was upside down (otherwise the visor would not close). This required the camera to be set on upside down in the menu which is easy to do. Other than that, the harness works ok, it's easy to adjust the camera fitting and the angle for best capture of bike dash/road ahead. The harness is quite sturdy although the means of tightening the harness to the helmet could be considerably better, it takes some manipulation to get it on nice and tight.

Can't recommend this enough!!! I've finally found a chin mount that actually works properly. This is actually one reliable piece of kit.Works so bloody well, managed to capture some footage on the way home from work and it looked astonishing.The camera recording felt smooth too in playback when it was mounted on my helmet compared to being mounted on my bike handle bars with vibrations. The product looks great too and I'm overall damn impressed, can't recommend this enough!There's so much room for adjustable movement too. Definitely go for this one.Pros:Works as intendedAllows you to move camera into placeEasy setting up.Works well with open front face slide up helmetsFairly comfortable, doesn't make the helmet uncomfortable.Looks great too, the colour is more of an orange vibe which isn't too bad.Easy to position on the road and before lifting off.Includes spare strap, overal it's just a general high quality piece of kit.Cons:Lack of different colour optionsDepending on camera weight, it could feel a bit heavy where the camera is mounted pushing your helmet down sometimes. Not a big issue at all but definatly worth noting.

Works absolutely fine.

Straps to my helmet nicely. Had to cut a small piece of rubber off so I can completely close my visor. Holds really well in high speeds and footage is very smooth. Straps need tightening slightly before riding but that is to be expected. Used with GoPro Hero 9

does the job brillianly.

Fits absolutely perfectly, even though i have a flip up helmet and i still have plenty of room to get to the release button. I have been looking for a Go Pro mount that didn’t rely on a sticky pad so this does the trick. Slight adjustment means that the visor closes with no issues.

This helmet has been a nightmare to get a camera attached to but this chin strap seems to have done the job. Camera feels nice a firm on the helmet, was a bit fiddley to put on but went in the end. Unable to shut visor fully but that shouldn't be much of a problem as the gap is small.

No se ajusta bien a ningún casco, no usa materiales con elasticidad y tampoco son lo suficientemente duros así que, si no se tiene cuidado, se parten. Sirve como un apaño temporal, pero a largo plazo no es una buena opción

Senza dover bucare nulla sul casco ....si monta facilmente .

Sehr gut

Ottimo prodotto