uxcell Silicone Tubing 5/16"(8mm) ID x 1/2"(12mm) OD 6.6ft(2m) Silicone Rubber Tube Air Hose Pipe for Pump Transfer Clear

Very brawny, a bit stiff but workable. Overall a good choice over all of the other flimsy tubing options.Takes heat well, I used it to insulate the shaft of a soldering iron up to 400 degrees so I wouldn't accidentally burn a wire or another component on the board.

As a car enthusiast I found this particular tubing to be ideal for my oldSchool Honda restoration project. (Accord Ex V6) After a lot of searching I found this ideal sized tubing for replacing the windshield washer tubing. The old stuff appears to be clear vinyl tubing which has become very hard and stiff, and has turned black with contaminants. YucK 😝.This particular 4mm x 7mm silicon tubing is perfect !! It’s is nice & clear, is heat resistant for being in the engine bay, flexible but not mushy, and has the ideal thickness of sidewall. The typical tubing has a sidewall thickness of 1.1mm whereas this one has a sidewall thickness of 1.6mm. Due to this slightly thicker sidewall it’s sturdier and nicer to work with.The only slight inconvenience is that this is coming from China apparently and took a few weeks to receive.

just the same as you see, flexible clear tube

I cut off lengths to feed my El Wire through to help give firmness to outlining my PEV Scooter mirrors for some fun effect and visibility at night. Works great as long as your El Wire is not color tube coated, as far as this size tube goes.NOTE: I had to use some silicone lubricant to help assist the wire through, and it's messy, but then I used an air compressor to blow out the lube as much as possible.

Brake fluid resistant, great size and durability for brake fluid bleeding.Used it for two months in busy shop, no signs of wear!

it is for scroll saw of blow

ok

well made, I use it for a variety of things