Amerock | Cabinet Hinge | 1/4 inch (6 mm) Overlay Hinge | Satin Nickel | 2 Pack | Self-Closing Hinge | Partial Wrap Hinge | Cabinet Door Hinge

Great value, solidity, and look. Too early yet to tell how these will hold up to daily use. If you are replacing full wrap hinges that use only a single screw into the cabinet frame, make sure you measure to drill the top of the two holes on these partial wrap hinges down far enough from the top of the cabinet opening to accommodate the clearance required by your drill. To save re-drilling the holes on the cabinet doors, do this before you mount the hinge on the cabinet doors. We installed a magnet on all doors to ensure that the doors will always fully close, even if eventually someone accidentally opens the hinge too far, or the self closing hinge mechanism simply weakens over time, as the original hinges we replaced did.

Building a cabinet around router table, I wanted access to the center space for any router adjustments.But if hinged right or left it would swing into drawers.Fold down use was perfect.

Used on kitchen cabinet doors

Wow, I bought regular hinges for all my cabinets and the ones near the wall didn't have clearance space so I bought a few of these partial wrap hinges. These hinges are much easier to install and have a very small clearance space required. Now I wish I had bought all the hinges this kind. Self closing works nicely. Hinge glides smoothly.

I am very happy with these hinges. I used them on a doll cabinet for the kids. They are just what I wanted with the range of motion and the self closing action. They work very well and were not too heavy duty for my needs.

I searched all over for replacement hinges for my cabinets. I had gold, and wanted satin nickel. These are not exactly the same design as the hinges we replaced, but they are the right size and worked perfectly. They look great.

The hinges are very good quality and look very nice. I had a couple of the screws snap in half during installation.

I ordered a pair of these and they would be perfect if it weren't for the lack of quality control. The machine brushing is done VERY poorly on the outside of the hinge that will be showing. There is a very uneven 'line' past which there is no brushing at all. Oddly enough, all of the faces that will not be seen because they will be against the cabinet are done very well. I requested a replacement pair, only to receive another pair that has the same issue. Because we are unable to find or order these hinges from a brick and mortar store, we're going to have to go ahead and buy these flawed ones and attempt to 'brush' the finish in ourselves. I am extremely disappointed to have to try to fix a new item. I also contacted Amerock directly twice to inquire about the problem, only to receive no response whatsoever from them. If I had another option, I would definitely NOT buy this flawed hinge.

Replaced my old (1986) dark bronze hinges on the kitchen cabinets with these. While the door holes weren't a match, the frame ones were and the finish matched the replacement handles I'd previously installed.Installation was very simple - hardest part was reinstalling the larger (pantry) door without a second pair of hands.I chose to use the screws from the previous hinges based on the feedback from other reviewers about how weak the provided screws were. I also didn't use the included felt door guards as I had good quality rubber/plastic ones already installed.

Make sure you clarify the back-set.

My kitchen cabinets are from 1987. It's tough to find nickel 1/4 inch overlay hinges. These fit the holes from my old hinges exactly. The screws are fragile. I snapped 2 heads off. Put your drill on the lowest setting and you should be ok

If you need to replace 25 year old 1/4 inch overlay hinges These are the hinges you need

WHEN I PURCHASED THESE HINGES THEY WERE ON SPECIAL AT A SUPER PRICE POINT!I DO NOT KNOW THEIR CURRENT PRICE. SUPER PRODUCT!