Highwild Adjustable Paper Target Stand, Frame with 8 Clips | Clear Bullseye Targets Sheet for Shooting Practice

Set it up without instructions inside of three minutes and it held up well, including getting grazed twice by 12ga slugs. Slight bend to the arms after being hit, but it banged out fine with a hammer at the range.

Simple, sturdy, and effective.Threads a little sloppy, wish it was taller. Provided clips are useless. I use zip ties. Already hit center column with a 9mm and it held up ok. I'm proud of that because it's only 1/4" wide.Nice shootin Tex!

A little fiddley to set up, but all the hardware was in zip-lock bags and it was easy to assemble. I have rocky ground so I always have to hunt around to find a place to drive anything into the dirt. The horizontal cross-bars are threaded which is also good. Threads were good quality/good cut. I mounted 14 inch targets with the provided butter-fly clips (I think the formal name are spring clips). Anyhow they stayed attached and once I got it set up I spent the rest of the afternoon sighting in a scope on an air-rifle. Nice little piece of kit. I saved the box for storage.

Did great for first use. However, I was using 5-bullseye paper targets the second use and hit the lower bar when aiming at the lower left bullseye. This resulted in one bar being destroyed (see pic) and the second one warped. There do not appear to be replacement bars, so it is now limited use unless I buy a whole new unit. If you are going to buy this, use single bullseye targets only where you can stay away from aiming near the target holding bars.

I have never bought a target holder before, so I did not know what to expect. This was a pleasant surprise. It is well-made, easy to assemble and holds a variety of sizes of targets and disassembles easily to fit back in its original box, although I am thinking of getting a bag for it so that I can leave some of it assembled. It does have quite a few pieces that take a few minutes to assemble. The only problem I had has is that one of the thumb-screw holes was x-threaded. I contacted customer service, provided my paperwork, and they sent me a whole new holder even though I suggested they just send the defective part. The only complaint I have is that the targets are held to the metal rods with conventional paper clasps (provided), but if there is a x-wind, they tend to allow the target to slide a bit and bunch up. I think with experience I will come up with a way to prevent this, like folding the target around the upper and lower rods and then clipping them.

It's ok

This target stand is worth the price paid. However, one of the two horizontal arm connectors arrived with a piece of brass stuck in connector. It looks like the tap that made the screw threads broke off and stuck inside the connector. I would have returned the product but, because I needed the target stand, I was able after about 15 minutes to screw the broken piece out of the connector. I was able then to screw in the arm but the threads of both the connector and the arm were damaged and the arm doesn't fit well. I don't feel it's right to return the product now because I used it but the arm doesn't fit well and the arm is being held in place by the paper target, instead of the arm holding the target.

Works well for my purposes. Pretty basic but the price was very good it does what I need. Only complain I had is that the clips that hold the target or a bit small and not reliable. Ordered some bigger clips for a few bucks and problem fixed.