ProMag Vise Block for 9mm Glock, Black

The ProMag Vise Block is Perfect. It's "no-mar" design is simple, genius and it's inexpensive!!! It frees up both hands to work on, clean, or modify your handgun. As soon as I opened the ProMag Vise Block package, I dropped the mag out of my Glock 23, Gen. 4, 40 cal. and inserted the ProMag Vise Block and it fit like it was an OEM Factory made Glock Mag!!! It dropped out just as easy and clean with a simple push of the mag release.I will be purchasing more of these for all of my firearms soon.Thank you ProMag and Thank you to Amazon for distributing their product line.

This works fine with the 9mm Glocks I have, but the main reason I bought this to use in the vice to hold the lower of an AR 9mm I guess you could call it. The lower locks right in and need to use the mag release to remove it. The picture shows it holding the 9mm lower along the side charging upper. Just what I needed and works great

I put this Promag Vise Block into my table top Panavise 301 which basically gives me a third hand to work on my Glock. Material is a stiff polymer and locks in to the magwell just like a magazine would into any 9mm Glock. The round portion goes into any vise and then hand tighten your vise to find the ideal position to work on your Glock. Overall a very handy accessory to have on your workbench along with the Glock dissassembly tool.

Bought this for building and maintenance on my QuarterCircle 10 9mm AR pistol. It's a little wobbly but does lock in and engage the magazine catch. It provides enough support to effectively torque down the buffer tube castle nut. Makes cleaning a snap just like my 5.56 AR vise block does for my rifle. Could be better, but it works so I have no complaints.

its a great tool but does not hold firmly, still does the job

Fits decent, you have to use the mag release to seat it though on most guns. I bought it for my AR9 but it bends quite a bit due to it's height. Anything that requires a decent amount of torque should be done with extreme caution.

it works, lots of rattle, sort of a loose fit in the magwell of my QC10 lower, makes it a little difficult to get a solid grip on it without it moving. would have preferred it was a bit tighter, but it did work. Might be better in an actual Glock lower.

Bought this for a Kel Tec 2000 40 cal and a Diamondback DB9r in 9mm and it works on both. Both carbines use glock mags. Looks well made and I am glad I bought it.