8" White Led Strip Light

These little puppies are BRIGHT pure white light. I ordered an aircraft rheostat dimmer and wired 4 of these units to it so I could dim to my hearts desire. It worked perfectly, looks amazing, and the rheostat is literally a fraction the cost of "purpose built" led dimmers. I highly recommend this setup to anyone wanting professional, adjustable, and affordable interior lighting in their boat. I even installed a blue 8" set in the bottom of my built in cooler on the boat... it's a HUGE crowd pleaser at night! I ordered everything necessary for this install right here on Amazon too!

Added this light to my RTV under the bed of the unit for an area light and to light up the trailer hitch for night work. I like that it is a sealed unit for water and dirt and dust.

I cant believe how dim these lights are, waste of my money and I will send them back, don't buy if you expect typical bright LEDs cause these aren't the ones . I saw on you tube and they appeared bright. Installed one on the front and back of my center console for night fishing and its worse than a single cell flashlight.

This was just what I was looking for. I have a lighted address sign above my garage. The sign came with 2 wedge based incandescant bulbs. I wanted to retrofit the sign with something weather and waterproof. I purchased this, and now my sign is greener because I am using low voltage LED's and I could not be happier with the quality and the performance of this light strip. I highly recommend it for outdoor applications.

Used on walkway, 8 inch gives much nor light than 6 inch! Hope they last!!!!

Easy to install and completely watertight. Not as bright as similar products but still worked great for me.

Good brightness and easy to install. Mounted this to the cage of my Polaris Ranger and using it as an interior light. All leds are bright and holding up well to the vibration. Great little light for the money and holding up well so far.

The lights I received that work are decent, but several of them on the backside were not properly sealed. On a couple they were obviously tilted while the potting compound was wet and one side is covered while on the other the circuit board is bare. I've ordered about 20 of these lights and this affected 3 of them, the others were fine. Just be sure to check the backside, especially if they are going to get wet. You can add clear silicone to backside to seal them.FYI: these are the same as the TH Marine lights so here, just relabeled.

nice and bright for my needs