[DIYE] Premium 3D Printer Glass for Creality Ender 3 Bed Plate End Cuts 4mm Thick Borosilicate

Get the cheapest hair spray you can find and it'll hold your prints like glue. Remove it from the bed after printing and your item will pop right off in a few minutes.Also, get these clips and you'll be happy with the setup. https://www.amazon.com/dp/B09L16TNN8

So you want shiny on the bottom prints?Do you want a surface that transmits heat Great?Glass. But this is Borosilicate Glass the stuff they make Baking pans out of. Very High-Temperature Shock Durability. And, it's Kinda hard to break too.Yea, it's Thick, and Nothing wants to stick to it (Big Secret: Hairspray fixes that)Mine helps with the warp in my bed too.

Worked great for a couple weeks.When it died I found out that the only "Customer Service" comes from their user forum.If I wanted an education in electronics I would have bought a radio.The frame and bed are solid, but everything else is the cheapest crap available.

I cannot address other reviews, but my glass bed is nice and thick and flat. It heats up very quickly and is great for use with high-heat printing., I layer mine with 50/50 PVA and water spread on with a foam brush. After application, simply warm the bed to 80C and it dries instantly and is ready for use. This is a fantastic upgrade for those who wish higher bed temperatures.

I've previously purchased another glass from another site but it was thinner and ended up breaking after removing a large area cube. I used hair spray instead of a glue stick which I find works much better. This glass was definitely thicker than the others being sold out there. It needed a couple of degrees of heat, but not much difference. I've had no problems with edges on mine. Thank you!

Works great, it’s just a piece of glass but once you get the settings dialed in it makes some sweet prints

Instructions on how to level the bed was not in the instruction had fine out the hard way

It fit the ender 3 perfectly and it's easier to level the bed the glass is nice and thick so you have to move your stop on your ender 3 up so you can level a little bit all in all completely satisfied the sides of the glass was nice and smooth 👌

Perfecto para una impresión limpia y de calidad. En piezas de media más a grandes no es necesario el adhesivo.