55079049AA Front Windshield Washer Nozzles Wiper Spray Kit Single Hole Compatible with 2005-2016 Grand Cherokee, 2005-2013 Malibu, 2005-2010 G6, 2007-2010 Aura | set of 2

Excellent replacement part. Easy to install.

These are an easy fix for replacement. If I wasn't so short I could have done it myself.

Fit was fine, spray pattern is great. After two years though, they keep popping out of the hood and will need to be replaced again. I paid $6, two years ago, so I think it was a good deal.

My passenger nozzle on my 2010 Grand Cherokee broke once and I fixed it with super glue. A couple years later it just became too brittle and completely shattered. Found these online and in 5 minutes I had swapped out the old one with the new one. (Hardest part of install was getting the hood padding removed so I could access the nozzle - it took like 5 minutes.)Would 100% recommend if you're looking for a replacement for the 2005-2010 Grand Cherokee models.

I installed these windshield washer nozzles on my 2012 Malibu and they are TERRIBLE. They fit fine but the washer fluid barely hits the windshield. They may as well be hood washers. No way to adjust them.No wonder the GM originals cost so much, they work. Buy once.

I'll start with the end: I'm keeping this item.A few things were left to be desired:>First off, the lower body was slightly too wide for the holein my hood; I fixed this by smoothing it down with a rotary tool and it slid right into place. The fit isn't 100% because the retaining tabs didn't fully engage; not a deal breaker as it's not like they fall out, they're just not as snug as OEM (which locks hard into place).>Next, I noticed 1 of the 2 did not work very well and sent a stream instead of a fanning spray. I only needed one nozzle so having at least one that did work was fine.>Lastly, the pressure isn't as strong as OEM so you get slightly less coverage. I put my good OEM on the driver's side and the aftermarket on the passenger's side.

Fit 2015 Jeep Grand Cherokee.Not too difficult to install, basically open hood, carefully unhook the tubes to the old sprayers/nozzles.Take the old sprayers out with pliers from under hood, they will probably break. The bigger pieces come out from top of hood, the smaller pieces will fall somewhere or will already be stuck in tube. Make sure the tubes and connector do not have any broken plastic left in them from the old sprayers, mine did and it would have blocked the flow.If the tubes or fitting are broken, get the whole kit instead of just these sprayers.Put included little rubber gaskets on new sprayers. Put sprayers through top of hood and they snap in. Connect tubes back onto new sprayers. Just be careful as all the fittings are plastic and could break. I used a little dish soap on the ends to allow the tubes to slide onto the sprayers more easily.They seem to work pretty well. The spray pattern is wide and reaches top of windshield. Old sprayers had metal ?misters? inside, these seem to be all plastic. I have no idea how long they will last, and will forget to update this review, or just not care to.

Excellent pricing compared to OEM, one sixth of the cost, and they work perfectly. Would buy again.