Mikalor - Supra W2 63mm-68mm Stainless Steel 2.25" T-Bolt Hose Clamp (Qty1) - 119-06300-1000

These seem relatively high quality, but I would not recommend using them for exhaust pipes even though these were recommended in the exhaust parts section of Amazon. They are much too thin and not strong enough to hold an exhaust together. I installed these on my BMW E30 with H&R race springs (stiff and lots of vibration) and after only a month or so, the muffler slipped off of the midsection pipes coming from the catalytic converter. I bought some stronger clamps and it is now holding well.These might be good for coolant hoses or intake piping, but not exhaust.

It is good but the bolt needs to be stronger. A higgrade will be great.

The size is listed incorrectly. It is listed in mm and also says 2 inches. The smallest it will go is 2 1/8”. It looks like a good clamp and I will order a smaller size.

I had a problem with hoses blowing off at 18lbs, ended up screwing self tappers in most of them. This one will hold. Its a little too expensive to do all of them.

The clamps were made in Spain with about average quality (rough edges and welds on the bands). OK, but also not as described. The band was 19mm (3/4-inch) wide and not 1-inch as stated. And, toggle style bands are easier to remove when not removing the hose.

Product description is accurate, and of good quality.

Good product. It was slightly larger then I needed but I still made it work. Construction of it is on par with the price

Purchased a Racefit black edition slip on exhaust and this mated the titanium pipe and down pipe from the headers perfectly together.