Does anyone have a positive experience in removing OLD oil stain from concrete?

I had a massive old oil spot on my concrete. Thought I just had to pour it on and watch the magic. Nope, you have to pour it on (I didn't dilute it), then scrub it for a minute or two, then rinse it off with the hose. Did that a couple times because the oil seeps back from underneath, and we are good! If this isn't working for you, try again, but make sure to spray it off with the hose!

How can i used this product in car engine? What step should i follow?

Engine has to be cool. Cover any or all electrical components that will get damaged with water. Spray Oil Eaters and let it soak all the gunk. Works best when used with pressure washer. Do not spray straight to electrical distribution boxes or Fuse boxes. On some newer car you can get away with not covering ay electrical harness or components. On older cars you may want to use precaution measures and cover these items with zip lock bags trash bags,etc. After rinse let the warmth of the car dry the excess water for about 5-10 minutes. Remove all covers. Start you car and let it run on idle these way your car can generate heat and dry any remaining water. If you engine begins to run rough you might have moisture or water in you electrical harness,distributor,coil packs or spark plug and wires. Best if you disconnect the wire harness/plugs one by one and inspect for water intrusion or moisture build up. Once you locate the issue let it air dry or spray with compressed air. If you do not have a compressor and air gun available, a computer aeresol spray will do. I used isopropyl alcohol in the past, but alcohol will remove the corrosion preventive coat. Petroleum Jelly like Vaseline can be applied. Auto part store have a variety of electrical grease you can get. Ensure that you induction system is air tight. If equipped with carburator, make sure that the dish is seal and as a prevention spray around the carburator and its components. Key points, cover electrical components, spray away from electrical distribution boxes,fuse box and other electrical components. And ensure your induction system is sealed. There is some prep work that has to be done before you spray you engine with any liquids. Oil Eaters will do your dirty work. Rinse at your own discretion.

Manufacturer	Kafko International, LTD
Brand	Oil Eater
Model	Cleaner Degreaser, 1 Gal
Item Weight	8.5 pounds
Product Dimensions	12 x 3 x 12 inches
Item model number	AOD1G35437
Is Discontinued By Manufacturer	No
Manufacturer Part Number	AOD1G35437
Special Features	Concentrated, Non Abrasive

Oil Eater

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة