12V electroluminescent Inverter for EL Panel Strip Wire Back Light by glowhut.com

Worked great on 08 sebring. Shipping sucks. Amazon left another package next to my gate on the ground in a rainstorm, says left in mail box. One other review said it won't work on 07 and up. It does just fine.

It works perfectly on 2001 Sebring cluster little bit too big but it fits

Didn't work how I thought it would.

I bought this to repair the dash lights on my 2005 Sebring Convertible. There are absolutely no instructions included and it is not an exact replacement. Installing the unit could be a little daunting for someone without a good understanding of automotive electrical systems. This unit is a little larger than the factory unit and you may have to get creative with mounting locations. In my case I just sat the unit in a small void behind my instrument panel. Wiring is pretty straight forward just be sure to connect the red wire to the B+ connection. Black with red stripe is ground, and the two solid black wires connect to your glow panel, polarity is not important on these.My main complaint with this unit is that there is some flicker when you turn the panel lights to dim, otherwise the result is quite good, and the panel is brighter than factory.

Does not fit properly and no response back from the seller

The inverter was received well within the stated shipping time. It was installed and is working very well to illuminate my dash lights. After about a week, it started making a high frequency noise. It's still working but, I think it's just a matter of time until it fails.

After purchasing 4 of these (would buy more but they aren't stocked in bulk on Amazon.), I will submit the following description:About the inverter itself:The inverter is a solid block, takes 12VDC and puts the output on a female JST SM 2-pin connector, which makes it compatible with nearly every EL product on Amazon. The length of the wire on the output is around 18 inches.My experience:I had an inverter fail after continuous usage 24/7 powering 3 10 foot lengths of EL wire. The failure caused the inverter to use > 2A of power, and there was a bulge on the side of the inverter. No big deal, at least it's not hard to figure out which one failed. I will be purchasing several more of these inverters as they become available. The glow on a single 3 FT EL strip (sold by GrayBean) powered by this product is brighter than the battery pack inverters that came with the product. The inverter can be powered by a computer power supply.Update:A new inverter has failed after 50 hours of continuous usage powering 10 feet of EL wire. Same failure mode as the first inverter, except this time there was smoke and the inverter did not short the power supply.I would not recommend powering these inverters off the same power supply you use to power your computer.To the manufacturer:I would like to purchase more of your products on your website, specifically your EL wire without an associated inverter (currently no one sells this on Amazon), and your male and female JST SM 2-pin connectors for electroluminescent products, and your EL panels.. but I don't trust your site with my information. Please make these available on Amazon.

Fixed a 2000 Chrysler Sebring Convertible dash light issue with this. Flickers on the highest setting so backed off to clicks on the light setting and works fine, for a cheap fix this is no big deal.