Brush R232-18 1/4-Inch Nap Epoxy Glide Roller Cover, 18-Inch

"Durability" rating is a joke and I'm tired of pointing out dumb rating selection. They're single use rollers if you're on a job to make money. If you're an old timer, you'll spend an afternoon squeegeeing them clean and use them again ten years later so perhaps the durability rating is for an extended re-use period (nobody makes uncoated paper core roller covers any more). On to actual feedback. These do work great for epoxy floors and I'll keep buying them for that purpose. Fun fact, I'm never going to clean them for re-use, so I'll never evaluate "durability" as more than three stars. Unless they mean "did it fall apart on the job" then it's five stars all the way. They should switch the rating to "shed resistance" which would be useful for a roller and I'd rate it four to five stars. Nice packaging, though, comes with a plastic roller cover and end caps which is helpful for bulk storage.

I used this to roll KBS Coatings Diamond Clear on to my floor. It's a product that is very similar to epoxy. It destroyed my regular brushes and rollers, so I knew I needed something special. These rollers are pricey, but nothing else worked. Tackled a tough job easily. I highly recommend this roller if you need something extra heavy duty. But you will need an extra long 18" holder for it, and a screw-on pole. I got both at Home Depot. Just bring in the roller, and they can direct you to what will fit. After 2 uses, the rollers were so plasticked up with dried epoxy-like coating that I did have to discard them, unfortunately. No good way to clean them.

Used two of these on my garage floor epoxy costing project. Worked exactly as expected and did a great job of speedily applying both the epoxy base coat and clear coat. The extra wide roller also helped speed application of the epoxy, in the past with a standard roller I’ve nearly run out of time with the epoxy curing before I could apply all of it.

Worked well for applying Rustoleum Rock Solid to my garage floor. Did not fall apart or flake off when using. Did a 3 car garage with one roller. Thought i might need two rollers but just one did the job!

I used this to seal my 2 car garage with a high acrylic AR500 seal by foundation armor. I used 1 roller per coat. tossed after use. for a smooth garage floor surface the 1/4 is good... but for a more rough surface like a driveway snag the 3/8

Used to apply epoxy coating to garage floor. Excellent results!

I really like these for epoxy applications. As with any epoxy project, take the necessary precautions to make sure the roller is ready before letting it touch the floor.

I bought this to put the swirl marks for epoxy floors to give the marble look. It created air bubbles everywhere. I would have taken a picture but I had to use a blow tourch to get the bubbles out before it dried... might be good for straight rolling

It made the job of epoxying the 600 sq. ft. garage floor easy and quick and rolling out the epoxy went on smoothly. Did not leave any nap behind, I only used one roller.

I only recieved one when I ordered two rollers

Pour application de peinture epoxy