Circo 12-EZ Light Grip ABS Snap Clamp 3/4 Inch X 4 Inches Wide

I'm using to attach to PVC piping shade cloth and both summer and regular weight fabric cloth, and works way better than anything else I've tried. I'm in the Mojave Desert so have high heat and high winds - 50, 60, 70+ MPH gusts. Fabric stays on like nothing else - tried super big cloths pin-type clamps, also tried the metal conduit supports I used to fasten the PVC pipe into the side of wooden raised beds - these are cheap and work well with only light wind (better with the thicker shade fabric), but can't hold once it gets to 20 MPH+. My PVC piping are rectangular structures around raised beds, some with trellis going up, the rest are piping to hold fabric. Tops are flat (so I'm not using round hoops, don't work so well for me). Also, I'm not gluing the PVC pipe so I can reconfigure when I want, an so have the pipe fastened to the wooden raised beds with metal pipe (rebar) in the ground and up in the PVC pipe. All secure in the wind. But I also made several raised beds with cement blocks so the only PVC pipe support is the metal rods (rebar) in the ground that the pipes sit on (so no securing with conduit supports), and for those, with the other attempts at fasteners, the wind gusts have blown the pipes and fabric up and over, but with these clips, they hold fabric top and sides of the beds and must make it more sturdy a support to the pvc pipe frame as none have blown over since I started using these. I'm using the heaver-duty snap clamp for the top (not removing if possible -- they are very tight!) -- and the lighter weight EZ ones for the sides (none of those have blown off in the winds either), and bricks to hold the fabric on the ground (that works terrific in the high winds). Then the fabric is hanging down in separate sections for each side and none going around a corner as I found that impossible for access (especially on a windy day!); so at any time I only have to remove the bottom bricks and side light-weight EZ clamps and bunch the fabric up on the top and I have easy access to the plants (or open it up for bugs to pollinate), one side at a time, or as many sides as I want. (Some only have fabric 3 sides and top to protect from the wind.) Lastly, desert squirrels have discovered lunch in my back yard garden once they hop the fence, and I read that the fabric will also keep the squirrels out - even summer weight. I found that hard to believe but have tried it and it works, no more nibblers! Again, these clamps keep everything on just fine, without holes or openings for the little critters. I don't use near as many as pictured here, maybe one every foot or 18" or so, but then my pipes are all straight lines, my top is flat. Also, in my shipment one package was missing - no big deal - contacted the company and they were tops and immediately apologized and sent me out the missing package. Great product, great service.

I used these to clamp my green sheet material to a DIY PVC frame. They worked great, and held the sheet very tight. Great fit, very sturdy and easy to use. Removing them from the frame is possible, but not super easy. For my application, that is desirable as I don't want them to be loose.

Works great in the garden on every thing .Will be buying more.

It works fine for our shade cloth because the wind pasts through it. You do need to use a lot of it if you plan on using it for your entire green house... you'd be broke. I also bought the zip-ties which work better. The main advantage of this over the zip-ties is that you can take it on and off easily. I think what I'll end up doing is using zip-ties for most of the structure, then use this for the "door" to remove when I need to access inside.

Perfect for Snap Frames! Hold: I was worried this wouldn't hold or be tight enough, but it is! Build quality: I mean either way it's just cheap pvc plastic, you know what you're ordering, and that's what you'll get. Clamp quality: My name brand clamps that came with my original snap frame split pretty easily, these have held up much better. And they're a bit tighter hold, so I went ahead and replaced the ones that weren't broken with these too!

I'm sure this works great for the intended use and I'll try this out with my greenhouse material this Spring in the garden. My main purpose for the clamps follows. How to fix an office chair by using other products. My nice big $200 office chair finally had enough of my extra pizza and deserts. The gas shock finally would not stay up and I really didnt want to purchase a new chair cause $200. Not looking at the chair gas shock I ordered a generic replacement online. The chair was taken apart down to install the new shock but alas the brilliant chair makers put a metal piece over the shock where it can not be replaced. Enter EZ White Snap Clamp 3/4 inch x 4 inch. I raised the chair to the highest level then measured the clamp against the opening. A small cut with a hack saw and it fit like a dream. 2 hose clamps and the chair still sits at the high point. Of course you can not lower the chair again but since I'm the only one using it then everything works out fine. Very inexpensive fix to an expensive problem.

NOTE: THESE ARE EZ SNAP CLAMPS NOT HD CLAMPS AS STATED IN THE TITLE As stated in their description "HD snap clamps, for long term use (use EZ clamps for frequent use)" I need HD clamps but they sent me the EZ clamps "Light Grip, Item: 12-EZ"... As such, the below review is for EZ Clamps. I have kept these and reordered (hopefully I will get the correct product) but I think their problem is with the title description as they are not selling HDs but EZs, we'll see. First impression is good as the go on easy, fit snug and do what they are suppose to do. I am concerned about the quality of the material they are made from so I removed a star because I don't think they will hold up to heavy UV and harsh weather (extreme cold and heat). I must ask why they are not made of PVC material? They are made of plastic, light plastic and I had one already break on me straight out if the bag. Anyway, I am in Northern Idaho and we just installed them on the green house so they will get a severe test this winter and I will edit this review with the results...but I have my doubts.

I had made hoop structures over my 4x8 raised beds and needed something to hold the frost blanket on. I started by sewing ties to the underside, but it was time consuming. These just arrived and are great. They slip on easily and off so that I can tend the winter plants by lifting the sides. So easy and they seem sturdy. I bought 30 because I would rather have a couple of extras than to not have enough. Update: I am now using these clips to secure shade cloth over my lettuce. LOVE these clips

Habia buscado estas abrazaderas en la ferreteria y no tenian, las encontre aqui y a buen precio, las volveria a comprar.