Delta CreativeStencil Magic Adhesive Liquid (1-Ounce),

I use stencils to paint on wood. This works very well. You let it dry for about 10 minutes and then it adheres to what you are painting on. Much easier than taping it down. It keeps the stencil from moving. Love it!

Holds stencils well but leaves sticky sometimes stained look around design areas.

We were putting a very fine line stencil on fabric and had to get the stencil down tight. This worked well and came off pretty clean. A few times a little of the adhesive stuck on the fabric. I waited for the paint to completely dry and using a small piece of tape could pick up any adhesive crumbs.

I waited until I've used the product a few times before doing a review.It does make the stencil sticky and holds the stencil in place pretty well.It does allow to pick up the stencil and stick it back down.You have to be careful to not put too much adhesive on the stencil. It will leave material on the surface of what you're using the stencil on if you do.You have to pay very close attention that you are putting adhesive on every little part of the stencil to be used. I use my stencils for airbrush work. If every single, tiny, piece of the stencil isn't stuck down, air from the tool can and will blow paint beneath the stencil.Basically, make a "snail trail" with the adhesive but do not leave "bumps" of adhesive on the stencil.Overall, I like this product for small stencils or stencils with tiny bits that need to be kept tight to the material.

This product worked as described. Will purchase again when needed.

I bought this to use on stencils because I work in a closed area and don't want to use a spray adhesive. So far it's been awful. I can't get the adhesive to come out and then all of a sudden there's a gush and it's everywhere but it doesn't actually keep the stencils in place.I'm probably going to go back to using a paint brush and Mod Podge

I thought that this would make stencils easier to use but it made it harder to use and it really didn’t do what it was intended to do… keep the stencil from bleeding!

I used this to stencil numbers onto a clock face. Worked perfectly and really helped to keep the stencil in place.