For iPad Air 1 A1474 A1475 Touch Screen Digitizer Glass Replacement with Tools and Adhesive (Black)

Perfect fit for my iPad Air. Easy to install. Sadly it needs help to stick but works perfectly

Looks good, seems to be good quality. Cannot write more as I haven’t used it. It was available in case I broke the original when changing the battery.

Really good kit let down by brittle plastic pics which snapped when trying to remove the old broken screen. Other than that does what it says.

Physically the product fits and the touch seems to work reasonably well, although i have a minor (about 1 square cm) dead spot on the bottom left, but to be fair i could have damaged the ribbon, or not seated it quite right due to difficulties i had in fitting. The adhesive is nowhere near strong enough though so I had to use some 3m electronics repair tape, basically i'd get one without adhesive over this one, i did try the adhesive on it's own first and it was utterly hopeless, and ultimately made the job more complicated. it is hard to get the screen to sit properly, which may well just be in the nature of this repair, I am a novice, but there seems to be a fair amount of upward force on the edges of the screen. Also i'd mention that my LCD has previously been replaced so this could be causing this problem. For me, as i just wanted a quick fix on an unusable, basically worthless ipad to use for a job and not really spend any money, it was just the ticket. but within a few days of use the home button has broken off its mounting, and even the super sticky 3mm of glue around the sides is starting to give up, so if i really needed the thing in top condition, i'd have to start over.

So, few weeks ago I finally had the time to change the screen.I thought it was great because it came with lots of little accessories and home button. Then when I started to install it, it became very apparent that the adhesive on the connector part did not stick sufficiently. I continued to instal. The whole adhesive did not stick properly but I used case to keep it together.Turned the iPad on, and it was not very sensitive to touch but worked with perseverance.A few days later it started to flicker between apps and go crazy, but ended up being rectified by turning off and on again.This became more and more frequent as days went on. And rather annoying! Few days later, home button stops working, and then followed by the screen doing nothing but going absolutely mental.It was a pain in the back side to instal, as are all screens which is why I was hoping for it to just settle down but it never did and now my iPad is done for.Completely gutted I’m just a few days out of a refund. Absolutely gutted and waste of money and time!

Removal of the original badly cracked screen was the toughest part of the job. Tools suppled were adequate [although I needed to supplement with my own thin plectrums - and patience - where the glass had been broken]. I only realised after final assembly that I should have stuck the side-ribbon down much closer to the screen edge [it's preventing a completely flush fit on that edge]but assembly was easy, and the peel-back dust covers and pre-fitted adhesive seem to work well. Plenty of good guides online but a one-sheet guide or even a link to an online guide from the order page would have been good.

Worked perfectly, only issue is that one of ribbons protrudes slightly. This means the glass doesn't stick near the cable. But such good value. I put a case on it and you wouldn't know

All good, prompt delivery.The hard bit is removing the old screen as it is securely glued. A hot hairdryer is not enough. It needs a heat gun. Once you get the old screen off, replacement is easy. The retinal display is underneath the glass and needs to be lifted out to plug in the 3 cables but that only requires attention to 4 screws. The product is ideal.