Shop FoxD4363 Accessory Pack for D4362 Guide Rail

Great product. Use it correctly and it never fails. I bought it for my shopfox track saw to join two tracks. make sure the tracks are properly aligned before tightening and you will not have issues. This kit is a must have if you're going to go all in with the shop fox track saw with two tracks. Clamps alone are worth the cost. If you're looking for Festool quality instead of getting the job done then you need to look at Festool bud.

Great tools much better price than the competition, however the set is needed to work with the track saw and should have been included not extra

Works ok. Taking the setscrews out of the rod is a bit of a pain and the screw clamps require two hands. I've gotten accustomed to quick grip clamps and may but the DeWalt version to replace.

Works as advertised. No problems.

Odds are, if you're looking at this kit you know about the rocking problem of all variants of the Shop Fox/Grizzly track saw. you can move the anti friction strips, or use the small anti-tilt attachment included in this kit. I tried with Shop Fox and Grizzly to get just that piece, but had to buy the entire kit.The kit is good value compared to the Festool equivalent parts sold individually, and there are some operations/setups that require clamps. The only reason I'm giving 4 stars instead of 5 is because the heads of the setscrews on the rail attachment bar are soft, and you should be able to buy the anti-tilt piece by itself.

Super poor quality control. One clamp doesn't even fit I need to grind it down.and the screws fall out of the attaching rail all the time. And I've only used it 4 times so far. I'm down to 3 screws.

They do the trick and hold track for straight cuts

the clamp seems low quality, the handle has a long crack from end to end, the notches on the back was not deep enough, seems it can easily slip. sending it back. now I have to spend extra to get festool

Estás se las recomeniendo a todos mil usos un poco más largas y mucho más útiles

It’s a must have to keep the track in place.

Nice to have to have accessories, come in handy

Worth every penny.

As many others, clamps are low quality and do not fit in the t-tracks. You will have to grind the top to make them fit.Plastic parts are not very impressive neither.Not worth the price at all.