FEL-PRO MS 92467 Exhaust Manifold Gasket Set for Chevrolet Silverado 1500

No more tick tick sputter.

Like the thickness of the gasket. Fit perfectly on 2011 2500HD and sealed properly.

These MLS gaskets worked perfectly on my 2005 4.8 engine

Good product

Used these instead ofMLS gaskets to fill any impurities on the head. Have been on for almost 2 years and have been good so far. For installation install header bolts on farthest sides, hand tighten them then hook gasket it then secure it with another bolt to ensure it doesn’t fall out.

Good quality fit and fit as it should. The hooks on the end of the gasket make life much easier on the install. I think factory torque spec was 18 ft lb. Be careful removing the manifold bolts, mine the infamous yellow GM thread lock. 2 of mine were already broken, one required me to weld a nut on to back it out so take your time and put some heat to them if don’t come easy.

I put these on a 2013 Silverado 2500HD. The exhaust manifolds were torqued to factory specs. The engine was ran for about 10 minutes to achieve temp. Then the engine was turned off and allowed to cool. The manifolds were then retorqued again to factory specs. No issues to report after 4K miles. I have years of confidence in Fel-Pro gaskets.

Fantastic

Installed on my Chevy 6 l. No leaks.

They did the job with no issues.Update: March 23 2019 These were installed on my contractor work van and the van still runs excellent with no exhaust leaks. Fel-Pro gaskets are worth every penny and should be used for any and all types of engine repairs.

the fit and finish is Fantastic.

Great quality gaskets. The truck no longer has tick fits. Sealed up and quiet now.

Fit perfectly, vortec tick is gone on my 6.0LAfter replacing these. Studs and doughnut gaskets also replaced at same time as it was apart and 4 studs snapped with the heat cycles