LED Bathroom Mirror, 24x32 Inch Gradient Front and Backlit LED Mirror for Bathroom, 3 Colors Dimmable CRI>90 Double Lights, IP54 Enhanced Anti-Fog, Hanging Plates Lighted Vanity Mirror

This LED mirror fits perfectly in my guest bathroom. The anti-fog feature works well and the varying light color with dimming adds value to the mirror. Overall quality is very good and was packaged well to prevent damage during shipping. Installation was pretty easy. Get many compliments on how nice it looks and the built-in light has good functionality. Looked at similar mirrors and this one is a great value for the price.

It is exactly and shown and described in multiple videos and on the Amazon product page. It is stylish, modern, and very functional. Perfect for a replacement mirror in builder grade bathrooms. It does everything the product page says it will do and provides lovely lighting options. Installation difficulty depends on each individual situation. We had to "rip out" the glued in builder grade mirror which left holes and torn drywall to patch, texturize, and paint. Then my husband (an electrician) cut a hole for the box in the center where the mirror would go and pulled wires to connect it up. Once that was all done it was simple to hardwire and hang the mirror (the video on the product page was very useful). This one was our test run. We love it and will be putting these mirrors in all our bathrooms. Just to note if you are wondering about the necessity for a separate switch: we have this mirror on the same non-dimming switch as the main light which is a bathroom over-the-sink light. We did not feel the need to add a separate switch since we can completely control the mirror lighting from the mirror itself. The second switch is for the bathroom fan. I like this because I can set the mirror so that it comes on with the main light, or not. I can set the mirror to be on dim or full light. We found that there was no need to over complicate the electrical part of this project.

Looks much better in person got this for my 24inch vanity easy installation not very bright but good light

I was afraid it would shatter on delivery but it was packed so tight and well with foam and the works that it was perfect upon arrival. Wired to a Lutron Caseta on off switch by replacing the vanity light with this (hardwired).Few notes: it will not work with a dimmer wall switch (that will cause it to act funky and flicker based on the manual). If you’re going to hardwire, you need to use an on/off switch. Smart switch is fine too. Just needs to be on/off.Second- to hardwire, you need to cut off the plug. The white power cord consists of two wires. One has writing on one side of it and the other does not. I cut the plug and used a voltage tester to validate that the wire with writing on it was indeed the “hot” side. The side without anything printed on it is the neutral side.Because this went in a bathroom, I replaced the circuit breaker with one that has GFCI protection. The leds and heater are controlled by a self contained unit in the mirror / what I assume is it’s all low voltage stuff but still, better safe than sorry. To make this mirror even better, I think it would be nice to have a ground cord too. I bonded the electrical box and (using the volt meter again) made sure that the metal frame behind the glass is not conductive. But still. A screw to the frame (or even better a third wire/three prong plug to cut off would be a design upgrade in my opinion.Overall - this sucker is HEAVY. Once it’s mounted on the French cleat looking brackets, it’s nearly impossible to just slide and center. If I had to do this again, I’d mark the center on the wall and on the mirror and line it up before lowering it into position. If you do what I did and just got the sucker on the wall, I found that two cheap bottle jacks from Walmart ($20), some rubber coasters (to prevent slipping) and a level (harbor freight) were the perfect combination to gently lift the mirror off the cleats a little (just enough to release the pressure) and allowed me to slide it. Without the jacks, this thing would not move at all (mirror is 60x40).Overall - i did a lot of Amazon research before buying this brand and don’t regret it. Great quality, bright enough to light the bathroom (though not as bright as the vanity light it replaced), and very elegant looking.I will likely buy two more smaller versions of the same mirror for the his and her vanity in the master bedroom. Smaller because this thing was literally a pain in the neck (still stiff) to lift and hang with two people - worth it, but heavy so maybe get a few friends and a 6 pack if you’re going with a 60x40 size.

Overall an geat buy ! It’s a bit more expensive than what I would normally spend on a mirror but it was worth it. The product was delivered very well packaged. Simple instructions, easy to use. The reason I gave it 4 stars because I wish I could adjust the lighting to brighter or less bright .

Because it doesn’t have borders so even the smallest one is big. I really like it. It’s easy to clean but it does show everything so I need to clean it more often. The anti-fog button needs to be pressed everytime the shower runs but it works like a charm. The auto button doesn’t work for me the lights keep changing but it is super bright on the regular setting. Easy to install

After about 5-6 months of having used this mirror, I thought it was about time to do a review. After months of constantly using it, everything works perfectly. The lights have not failed and the anti-fog function works amazing. I clean the mirror with regular window cleaning easily.

I knew it was a really great size for the price. But I could not have anticipated how gorgeous this mirror actually was. It was so beautiful that I had to put it in a different area in the house just so that people could see it. It also provides such clarity and light, which is perfect because I use it as a make-up mirror. I highly recommend!