KOLACEN Automotive Car Truck in-line 18 Gauge Fuse Holder for Mini Blade Type Fuse 5 Pieces + 10 Pieces Mini Blade Fuse 5Apm 10Apm

These DID work for me but 2 of them were wasted due to wires pulling out while stripping the ends. The wire is very thin inside and it appears they are not made well by not being seated into the end that reaches the fuse. Make sure you pay attention that you don't yank some strands out. If I could find a better quality version of this I would pay the difference to go that route. Again they did work but I have no idea if strands are broke inside that didn't come out.

These are nice for adding an extra fused circuit to a vehicle. As some reviewers mentioned, the fuse fits very tight in the socket, but with up to 10A going thru those little blades on the mini-fuse, the socket needs to be fairly snug to make good connection. I found that once your able to seat the fuse the first time, it's not quite as difficult the second time. I bent the fuse blades on the first try, so was more careful after that. The vehicle's factory fuse holders are almost as tight by comparison. Overall quite happy with the product.

Decent price for the amount you get. Better than going to the local retail store and paying the same amount for one holder.Had an issue getting the fuses to fit. Looks like during the production process the rubber housing found its way into the metal fuse holder slots. I had to dig it out with a knife before my fuses would fit. Just a minor inconvenience.

Fuse holder appears well made. Fuse is very difficult to install. Absolutely no danger of it falling out even if the rubber cap is not installed. Have a pair of pliers handy to remove the fuse.

These are the typical inline fuse links. They come with both 5 and 10 amp mini fuses which is nice if use both. Well made with what appears to be a waterproof (resistant) dust cover. The only thing was that I only needed 1 but comes in a pack of 5, I may be able to use them later, but buying only one locally was more than this delivered to me.

These are awesome! I removed the glass fuse housings and soldered these in their place on two TaoTao 125 kids quads. They offer better water and mud resistance. Quality wire and fuse housing. Fuse is a tight fit but not a problem.

nice product

They are exactly what I needed. They are easy to use, the boot seals fairly well. Use some di electric grease for sure around the boot connection.

They are automotive fuse holders, you probably wouldn't buy them if you didn't know what they were.Turns out they were exactly what I needed, so I fitted them to my motorcycle and the powered my sat nav perfectly.In fact writing the review took longer that ordering them.

Used these on Ebikes to provide extra protection. Compatible with the most common fuse type that is readily obtainable and cheap. No complaints, excellent.

Very easy to use.

It is ok but I will need a strong pliers to take the fuses out.

Tidy