ARYZE14 Pack Golf Club Sensor Covers – Durable Protection, Compatible with Garmin Approach CT10, Arccos Smart Sensors, Golf Pad Tag, and Other GPS Club Tracking Sensors (Black, Standard)

These work very well even on jumbo grips. I found it easier to apply by turning them inside out and then sliding them down.

Fit well on my Taylormade woods and putter as wel as my Mizuno irons. Easy to put on with a little bit of power.On the expensive side but worth it.

Work well but not good on putter

Does a great job at keeping my sensors on. Only downside is there is a little more resistance getting clubs back in the bag. But not a deal breaker at all. Worth the money if you have Garmin sensors on your clubs.

I have the Mizuno 923 set with the screw-in Arccos sensors and they were always coming loose. My driver sensor fell off a few times. I put these on my sensors and they are perfect. I have the Golf Pride Tour Wrap Jumbo grips. They do not interfere with my grip, they do not interfere with the signal for the club, and they do not come loose !!! PERFECT !!! If you have these sensors, you NEED these. It is still part of my ritual that when i touch the club to check to see if the sensorsare loose because i have had to tighten them every time i would swing the club. Apparently i was holding the club at maximum length and as the clup went through it's motion, i guess my palm would turn the sensor.... I am trying to get out of the habit of checking the sensor now because EVERY time i check it, IT IS TIGHT now thanks to these covers!! THANK YOU, i though i was going to have to put duck tape on them.... LOL

Fit like a glove over my Garmin Approach CT10's

Only reason for dropped star is I have supersized grips and these BARELY fit. Hard to put on and need to fix some every few months BUT no more losing sensors for reasonable price. I managed to keep sensors on by using shoe glue (which you can easily remove if need be) but tops (with electronics and battery) still kept coming off. I've had to buy a dozen replacements (half off when you call Garmin Tech Support). These are highly recommended.

I have taken them off my clubs. They keep sliding up, especially on the practice tee, where you swing the club several times. I bought them, because the sensors kept unscrewing, and I would lose them. Now, I just add a drop of super glue, and they stay on until I need to replace the sensor. A little harder to get off, but it’s better than losing them. And these end caps just create a bigger problem.