VEVORBlind Hole Bearing Puller Set, 16-in-1 Inner Bearing Race and Seal Extractor Kit, Slide Hammer Pilot Insert Inner Internal Bearing Removal Tool Set, 10 Adjustable Collects and Counterstay

Es excelente

OK, so the case itself is pretty nice, and holds everything in well. The slide hammer itself is junk, either too short a throw, or too light, or some combination of both? And the Collets are a mixed bag, half of them are machined poorly, one in particular was not threaded all the way so stripped some of the thread, and for some reason some don't like to spread uniformly, so getting them tucked in just so is near impossible.The biggest issue is the sizing- while it is advertised as "effectively removes tight and stuck parts ranging from 1/4 to 2-1/3 inches", the truth is there are gaps between the pieces that are included. For instance, one collet might expand to 1", and the next size up starts at 1", so that makes getting a bearing out that has an inside diameter of .99" impossible, because the collet that expands to 1" doesn't have enough purchase (.01" isn't enough), and the next size collet that starts at 1" won't fit through the inside diameter of the bearing. That actually became enough of an issue to the point where I could only remove about 2/3 of the bushings in the project I had, even though it was advertised otherwise. For a single bearing, or maybe a few different sizes, this might work well, but for my project, it was effectively useless.

I was able to pull multiple Pilot bearings out on Manual Transmissions.

Will not pull out the smallest bearing. Smaller collets slip and won’t hold. Slide hammer is way short and useless. The puller twists under any slight pressure and is also useless. 0 stars if possible

As described

Very good quality thank you.

If the collets has a 90 degree angle rather than a beveled edge they may have worked. I’m very disappointed with the set and I can’t recommend. The center pin is made of soft material and not durable and chewed up by the center of the collet. It wasn’t easy to removed the bushings. The sizes aren’t close enough to cover a wide variety of ID bushings.

I bought this tool directly from Vevor's website. I wanted to leave a review there, but I wasn't able too. Suspiciously Vevor only allows 4 and 5 star ratings on their websites, but fortunately Amazon allows for truthful reviews.To start will, the hammer is 2lbs, not 3.1 lbs as the description states. The combine weight of the hammer plus the rod it slides on, plus the T-Handle, is roughly 3 lbs, and that's why the tool can only be used for the lightest of applications. I spent 15 minutes trying to remove a 1-1/2" diameter bearing from a vintage Craftsman belt and disc sander. After 50 or so whacks of the tiny 2lbs hammer, I eventually gave up. Granted, there was some corrosion buildup, but still... To make this tool useful, you'd need a 5lbs hammer sliding on a significantly longer rod for momentum. For $50, it's not a bad buy, but don't expect too much from this light duty tool.