Ergo 3D Hopper Accessory for Electric Rolling Machine for Hand Rolled Smokes

Like others have stated, it IS a little loose, but I don't have a problem with that. I'm just careful not to touch it when depressing the lever. It sure makes it a lot easier, holding a large amount of tobacco at a time. I just looked at the instructions..it includes super glue, which I didn't use. (If the instructions are hard to read, I usually ignore them, like I did in this case.)

This Hopper I feels helps a lot. With it, it helps you see sticks and whatever you don't want before it goes into the machine. Also, you don't have to stop and reach for the bag so often to refill the tobacco. You can make a pack +, with one Hopper fill. It's worth buying it.

This has made the process much faster and works great, great design of the item. I removed one star and experienced the same issue as someone else, for future purchasers sakes please change the glue type to a thicker viscosity or just do not include glue. I had glued the mini hopper that comes with the powermatic as soon as I got my second one as there is no reason to have it removable for me and it irritated me when it popped off when I had tobacco in it so I had to install this with the unit and small hopper installed. I glued per the directions, waited a few minutes then set the item down. The superglue's viscosity is too thin and took too long to solidify, it wound up working it's way down into the door mechanism gluing it shut, I thought I would have to go buy a brand new powermatic after purchasing this replacement a week ago. After an hour of soaking in acetone and a hobby knife and dental pick I finally got it working again. Please do not include this glue or go with a thicker glue that is not so thin that it works its way into places it should not! If you have this issue soak a paper towel in acetone and holding the unit upside down hold the soaked towel against the length of the door and the two guide ways on the side, then use a pointed object to scrape the softened super glue off before it hardens again from the metal to metal contact area of the lid that closes and the guides on thesides, after a while this worked for me and saved me spending another $90 to replace my new powermatic.

It allows a lot more Tabacco to be stored so it makes it more convenient to make more cigarettes without having to constantly add more after 3-4 cigarettes. One full hopper can make over a pack of cigarettes at a time without adding more Tabacco. This saves time and money our rolling of cigarettes.

I like this hopper. It came well packaged and mine had no cracks and was made well. It does fit loose in the machine and I chose not to glue mine since I move it between two machines. Instead I mount mine using painter's tape which holds the hopper securely to the machine. The hopper holders enough tobacco to make about 2 packs of cigarettes of king size cigarettes. This hopper is just the right size for me. I would recommend this product to a friend.

Hopper fits very poorly. Where hopper mounts to machine there is an angle but hopper is not on angle. It sits slanted back. Does not meet bottom of machine so there is no support. Glued hopper to back of mount with supplied glue , slight bump knocked it loose. Overpriced for quality. A bad buy.

I love this hopper can make a pack and half now without refilling . Fit is great if you put it on right the 3M strip holds very firm and tight.

It's a good idea but doesn't stay secure to the machine for long. It also takes some practice to load the machine with the hopper in the way