Etoput 7 Inch Touch Screen Case Holder

It fits and looks great

The screen fits well but the feet are not big enough and it just falls over a lot. It does not cover the entire screen perfect but its pretty good.

There was no directions wich wasent a big deal u assemble things like this all the time with no directions but either this does not fit a pi 3....... or I'm just stupid

This case comes with no instruction manual and took a bit of guessing to get everything to work. The mounting holes in your screen also may not match up with the holes in the case. My mounting holes were above and below the screen, whereas the holes in the case were to the left and right of the screen. There are an assortment of screws, washers, and nuts in the baggy that comes with the screen, but the lack of instructions makes everything a guessing game. I ended up ditching the included hardware for screws, washers, and nuts of my own, including standoffs in order to make room for the heatsink on the chip located on the bottom of my Pi.

I bought this on a "guess" that I could adapt it to other 7" display. I had to drill out the holes and used metal spacers to keep the back plate from touching the middle and front plates. Used plastic sheet rock spacers to standoff the Raspberry Pi 3B+ from the back plate. This is not a problem with unit's manufacture. I was looking for a holder that would handle my GeekPi unit which has no holder for it. So with a little hacking around, it got a good holder for both 7" touchscreen and the Raspberry Pi. Very happy

The cutout for the displays flat cable at the bottom is not big enough and pinches the cable. The cutout for the ports is too small and the HDMI cable provided with the screen that is supposed to go with this does not fit. No other HDMI cables I had laying around fit either. Holes are also in the wrong locations.When I buy a screen and screen mount from the same vendor that are intended to work together, it is not acceptable to be forced to fix their mistakes. Read the other reviews, I am not the only one who had these issues. I am disappointed in the quality of this stand as the display is great, but won't work with it's stand.

Needs instructions. I had to modify this case to work with the raspberry pi 3 model b and Landzo 7" touchscreen, but possibly didn't need to. But if you have a pi and aren't into modding, then pi might not be for you. All in all I got it working, so "meh". I wound up drilling a couple holes and adding some washers, and didn't even use the middle plate. Had to extend the bottom front indent all the way to the middle to protect the printed circuit strip that wraps around the bottom of the screen.

I bought this for my Element 14 Raspberry Pi 7 inch touch screen. It does not fit the overlay. back pieces don't fit over display pcb. leg mounting screws are covered by screen overlay, can't use this at all!Not even 1 star!DO NOT BUY for Element 14 display!!!!