220x220mm Ultrabase Platform Glass Plate Build Surface + Aluminum Heated Bed Hotbed 12V with Wire Cable for Anet A8 A6 for ANYCUBIC I3 Mega for Ender 3 /Ender 3 Pro 3D Printer

I bought a mega pro and it came with a warped bed and ordered this as a replacement until I could find an original one. It all is plug and play, but you lose the 20mm since it is a tad smaller. I notice it takes a while to heat up, more than 2x as long as the Anycubic one. Ambient to 60 Celsius takes about 8 minutes. For what it is and the price, you can't really beat it I suppose.

Will fry skr 2 boards. Or at least i have killed 2 of them now with this bed. The thermal runaway mosfet starts cooking and eventually the bed fuse will pop. At this pint the damage is done, if you replace the fuse, it then burns until the board melts or sets on fire.No one can answer what thermistor to use for this bed in marlin firmware. i have it set to 1 in marlin for 100 ohm as i have measured it. Also i cant find how much wattage this heat element will pull. And lastly no info on what pid values could be used or if it is compatible.I assume bang bang tuning is too much for the board. With the limited to no info i cant find out if it is possible to tune this bed via pid. in my test prints before board frying, adhesion works great as long as i clean the bed well with 90+ proof. And use a wide brim raft. I will now use this with a 25A control board so i do not eat another skr 2. Using a bltouch this bed does not warp near at all, or it is because this is brand new and has only had 10ish heat cycles at 90 degrees.Mounting hardware looked flush to me and i had no issue installing onto the previous bed mount. (xyz davinci 1.0a)

The 12V heated bed works very well. There was no need to change thermistor in Klipper, it worked straight out of the box.PLA is sticking very well to the glass plate, so much so that the prints are quite difficult to take off. However, the glass bed is not flat. The mesh from BLTouch displays a range of 0.230mm across the plate. My autoleveling is accounting for the disparities but I will most likely replace this glass with a flexible build surface as well.

This bed works great. I was unable to get a replacement from Anycubic for my ultrabase, but this one retrofitted right in with no modifications. Have already ran 4 parts that took over 20 hours each and no issues.

If you're in the market for a new heated bed, absolutely get this one. I bought a cheaper bear bed on Amazon and it was a totally waste of time.The price is worth it for the heated bed alone, it comes with a thermistor and wires pre-installed. It also comes with the appropriate screws and as a bonus a very nice textured on one side and smooth on the other glass bed with holders! 5/7 will buy again

I tore up my Anycubic I3 Mega Ultrabase using PETG and no glue. This bed installed easily and fit perfectly. I would highly recommend.

Was a bit nervous with buying this at first. Once I installed it, and gave it a test run, prints stick no problem, maybe a little too well, but can get them off with no breaks. Nice and flat. Good product.

Great item , really happy with purchase,3d printer working as new!!!